Module 2: Mechanics and properties of matter · Lesson 2.2 · about 45 min
Work, energy, momentum and collisions
Work and the work-energy theorem, conservative forces and energy diagrams, the centre-of-mass frame, and every kind of collision JAM asks about: elastic, inelastic, oblique and with restitution.
Module 2 · about 45 minutes. By the end you will be able to compute work for any force, read an energy diagram to find equilibria and oscillation frequencies, use the centre-of-mass frame to solve collisions in a few lines, and handle elastic, inelastic and two-dimensional collisions without memorising long formulas.
1. Work: force times displacement, done properly
For a constant force and a straight displacement, work is a dot product. For a force that changes along a curved path, add up small pieces:
Only the part of the force along the motion does work. A string holding a stone in a circle, a normal force on a body sliding along a floor and the magnetic force on a charge all do zero work, because they stay at right angles to the velocity.
Worked example. N acts along . From to m: J. Multiplying the final force (12 N) by the distance (2 m) would give 24 J, which is wrong because the force was smaller earlier.
2. Kinetic energy and the work-energy theorem
Put into the work integral and you get a result that holds for every kind of force:
Power is the rate of doing work: .
Worked example (constant power). A 1000 kg car starts from rest and its engine supplies a steady 2 kW with no losses. Then , so m/s, and the distance in 9 s is m. The acceleration is not constant, so the familiar would be wrong.
3. Conservative forces and energy diagrams
A force is conservative if the work it does between two points does not depend on the path. Equivalent tests:
- the work around every closed loop is zero;
- (in a region without holes);
- for some potential energy .
Gravity, springs and electrostatic forces pass; friction and drag fail. For conservative forces stays constant. In one dimension , which turns a graph of into a complete picture of the motion.
- F = −dU/dx
- the force always points downhill on the U(x) graph
- U′(x₀) = 0
- an equilibrium point: no force there
- U″(x₀) > 0
- a valley: stable; small oscillations with ω = √(U″(x₀)/m)
- E ≥ U(x)
- the only places the particle can be; where E = U it turns round
- Physical meaning
- Picture a marble rolling on a track shaped like U(x), with total energy E as the highest level it can reach. Valleys trap it, hilltops balance it, and if E is above every hill on one side it escapes.
Worked example. A 0.5 kg particle moves in (SI units).
- Equilibria: at .
- : at it is 8 (valleys, stable); at it is (a hilltop).
- Near , : a spring of stiffness 8 N/m, so rad/s.
4. Momentum and the centre of mass
For a system of particles, internal forces cancel in pairs (third law), so only outside forces change the total momentum:
With no outside force the centre of mass glides at constant velocity, whatever happens inside: explosions, collisions, people walking on boats.
The centre-of-mass (CM) frame moves with , so the total momentum in it is zero. The kinetic energy splits neatly (König’s theorem):
The first part cannot change while momentum is conserved. Only is available to be turned into heat, sound or internal excitation. That one sentence solves most “how much energy is lost” questions.
5. Head-on collisions
In every collision without outside forces, momentum is conserved. What happens to kinetic energy is described by the coefficient of restitution:
Here is how the elastic results come out, with target at rest:
Two laws. Momentum: m₁u = m₁v₁ + m₂v₂. Energy: ½m₁u² = ½m₁v₁² + ½m₂v₂².
Group the terms of each body. m₁(u − v₁) = m₂v₂ and m₁(u − v₁)(u + v₁) = m₂v₂².
Divide. u + v₁ = v₂, that is v₂ − v₁ = u: in an elastic collision the bodies separate as fast as they met (e = 1).
Solve the two linear equations. v₁ = (m₁ − m₂)u/(m₁ + m₂) and v₂ = 2m₁u/(m₁ + m₂).
Check the limits. Equal masses swap velocities; a light ball bounces off a heavy one (v₁ ≈ −u); a heavy ball barely notices a light one (v₁ ≈ u, v₂ ≈ 2u).
With restitution and the same set-up, the general results and the energy lost are
Worked example. A 2 kg ball at 6 m/s hits a 1 kg ball at rest with . Momentum: . Restitution: . So m/s and m/s. Energy lost: J, which matches J.
A frame trick worth knowing. A ball meets a heavy wall moving towards it at 2 m/s. In the wall’s frame the ball arrives at m/s and leaves at 12 m/s; back in the ground frame it leaves at 14 m/s. The same idea explains why a small ball dropped on top of a big one rebounds to nine times its height, and how spacecraft gain speed from planets.
“In a perfectly inelastic collision all the kinetic energy is lost.” Only if the centre of mass was at rest. A moving lump of clay that sticks to a cart still leaves the pair moving, because momentum must be conserved. The energy lost is , the CM-frame energy, which is always less than the lab kinetic energy unless the total momentum is zero.
6. Collisions in two dimensions
Momentum is a vector, so it is conserved component by component. Two results save a lot of time:
- Equal masses, elastic, one at rest: the two bodies leave at right angles (unless the hit is head-on). Squaring and comparing with forces .
- Heavy hits light, elastic: the heavy body can be deflected by at most . An alpha particle (4 u) hitting a proton (1 u) turns through no more than about .
Worked example. A puck at 4 m/s hits an identical puck at rest elastically and moves off at . The other puck leaves at on the other side; the momentum triangle is right-angled with hypotenuse 4, so the speeds are m/s and m/s.
For a quick check of any collision with your own numbers, use the collision calculator.
- ; forces at right angles to the motion do no work. for any forces; .
- Conservative: path-independent work, , . Equilibrium at , stable if , with .
- No outside force: total momentum constant and the centre of mass moves uniformly.
- ; only the second part can be lost.
- Elastic head-on, target at rest: , . With restitution, .
- Equal masses, elastic, oblique: right angles after. Heavy on light: .
Practise: exam questions on this lesson
They start easy and climb to top-rank level. More on the work, energy and collisions practice page.
Before this: lesson 2.1, Newton’s laws and frames. Next: lesson 2.3 on variable-mass systems and rockets, then 2.4, central forces and orbits, where energy and angular momentum together decide the shape of every orbit. Going on to GATE? Central forces and scattering takes collisions into cross-sections.
Check yourself
Sources
- D. Kleppner and R. Kolenkow, An Introduction to Mechanics, 2nd ed. (2014), chapters 4 and 5
- J. R. Taylor, Classical Mechanics (2005), chapters 3 and 4
- H. Goldstein, C. Poole and J. Safko, Classical Mechanics, 3rd ed. (2002), chapter 1
- IIT JAM Physics syllabus (Mechanics and General Properties of Matter), published by the organising IIT each year
Your ticks stay in this browser. Save them as a file on the course home.
Updated 2026-11-22. Not affiliated with IIT or the JAM organising institute. Exam pattern as published for recent years: always check the official JAM website before the exam. All questions are original.