Home / Learn / Exam prep / IIT JAM Physics / Lesson 3.3
All lessons

Module 3: Oscillations, waves and optics · Lesson 3.3 · about 45 min

Superposition, Lissajous figures and coupled oscillators

How oscillations add: phasors for SHMs along one line, beats, perpendicular SHMs and Lissajous figures (and reading a frequency ratio off an oscilloscope), then coupled pendulums and spring chains, normal modes, normal coordinates and the slow swapping of energy.

Key points, meanings and formulas on one page: choose "Save as PDF" in the print box.

Module 3 · about 45 minutes. By the end you will be able to add any number of SHMs along a line in one step, explain beats, recognise every standard Lissajous figure and read a frequency ratio off an oscilloscope, find the normal modes of coupled pendulums and spring chains, and say exactly when energy swaps from one oscillator to another.

When oscillations meet, their displacements simply add. That one rule explains beats, the patterns on an oscilloscope and the strange way two linked pendulums take turns to swing: every motion of a coupled system is a sum of a few simple "normal modes".

1. The superposition principle

For the oscillators in this course the equation of motion is linear: x¨+ω2x=0, or with damping x¨+2γx˙+ω02x=0. If x1(t) and x2(t) are solutions, so is x1+x2. This is the superposition principle, and everything in this lesson rests on it.

It fails when the equation is not linear (a pendulum at large angles, θ¨+ω2sin⁡θ=0) and, in a different way, when it is not homogeneous: two solutions of the driven equation x¨+ω2x=F0cos⁡Ωt add up to a motion driven by 2F0.

2. Adding SHMs along one line: phasors

Picture each SHM Aisin⁡(ωt+ϕi) as an arrow of length Ai at angle ϕi, all turning together at ω. If the frequencies are equal, the arrows keep their angles to each other, so you add them once, like vectors:

A2=A12+A22+2A1A2cos⁡(ϕ2−ϕ1),tan⁡ϕ=A1sin⁡ϕ1+A2sin⁡ϕ2A1cos⁡ϕ1+A2cos⁡ϕ2
A₁, A₂
the amplitudes of the two motions being added
φ₂ − φ₁
their phase difference: 0 means in step, π means exactly opposite
A
the amplitude of the single SHM that results; it has the same frequency
Physical meaning
Amplitudes add like arrows. In step they add (A₁ + A₂), opposite they subtract (|A₁ − A₂|), and a quarter cycle apart they add like the sides of a right triangle.

Worked example. Add x1=4sin⁡ωt, x2=3sin⁡(ωt+π/2) and x3=2sin⁡(ωt+π) (cm). Arrows: 4 along 0°, 3 along 90°, 2 along 180°. The horizontal ones combine to 4−2=2; with the vertical 3, A=4+9=3.61 cm.

For equal amplitudes the formula shortens to A=2A1cos⁡(Δϕ/2). A favourite trap: two equal SHMs give a resultant equal to either one when cos⁡(Δϕ/2)=12, i.e. Δϕ=2π/3, not π/3.

3. Different frequencies: beats

If the frequencies differ a little, the arrows slowly turn relative to each other. For equal amplitudes the sum is

Acos⁡ω1t+Acos⁡ω2t=2Acos⁡(ω1−ω22t)⏟slow envelope cos⁡(ω1+ω22t)

You hear the average pitch, swelling and fading. The envelope cosine has frequency |f1−f2|/2, but loudness depends on the size of the envelope, not its sign, so it peaks twice per envelope cycle: the beat frequency is |f1−f2|.

Worked example. x=asin⁡(100πt)+asin⁡(104πt): frequencies 50 Hz and 52 Hz, so 2 beats per second, 20 beats in 10 s. Musicians tune by turning a peg until the beats slow down and stop. The Beats lab lets you hear this, and lesson 3.5 uses beats to find unknown frequencies.

4. Perpendicular SHMs: Lissajous figures

Now let one SHM move a point along x and another along y: x=Asin⁡ωxt, y=Bsin⁡(ωyt+ϕ). The point traces a Lissajous figure. For equal frequencies, eliminating t gives

x2A2+y2B2−2xyABcos⁡ϕ=sin2⁡ϕ
Phase ϕ Path (equal frequencies, A=B)
0 straight line y=x
between 0 and π/2 ellipse along y=x
π/2 circle (an ellipse with axes along x, y if A≠B)
between π/2 and π ellipse along y=−x
π straight line y=−x

The enclosed area is πABsin⁡ϕ, so it measures the phase difference. The sense of rotation depends on the sign of sin⁡ϕ: check where the point is at t=0 and which way it moves next.

Pick a frequency ratio and slide the phase. For 1 : 1 the figure runs line, ellipse, circle, ellipse, line. For other ratios count the touches: the top edge is touched once per vertical cycle, a side once per horizontal cycle.

Reading a frequency off an oscilloscope. Feed a known signal to one pair of plates and the unknown to the other. When the figure stands still,

fyfx=number of times the figure touches the top (or bottom) edgenumber of times it touches a side edge

Worked example. With 500 Hz on the horizontal plates, the figure touches the top twice and a side five times: fy=500×2/5=200 Hz. The figure closes only if the ratio is rational; for 2:1 it never repeats and slowly fills the rectangle. With two nearly equal frequencies it “breathes”: line, ellipse, circle, ellipse, other line, once per beat period.

Two curves to remember: x=Asin⁡ωt, y=Acos⁡2ωt is the parabola y=A(1−2x2/A2), and y=Asin⁡2ωt is a figure of eight.

5. Coupled oscillators and normal modes

Join two identical pendulums (length L, mass m) by a light spring k between the bobs. For small swings, with x1, x2 the sideways displacements:

mx¨1=−mgLx1−k(x1−x2),mx¨2=−mgLx2−k(x2−x1)

Each equation contains the other coordinate: the motions are coupled. The trick is to find combinations that are not.

Add the equations. With q₁ = x₁ + x₂ the spring terms cancel: q̈₁ = −(g/L)q₁. So q₁ oscillates at ω₁ = √(g/L).

Subtract them. With q₂ = x₁ − x₂ the spring terms double: q̈₂ = −(g/L + 2k/m)q₂. So q₂ oscillates at ω₂ = √(g/L + 2k/m).

These are normal coordinates. Each obeys its own SHM equation, with no trace of the other. q₁ and q₂ are the normal coordinates; ω₁ and ω₂ the normal frequencies.

Read off the modes. Only q₁ moving (q₂ = 0) means x₁ = x₂: both in step, spring unstretched. Only q₂ moving means x₁ = −x₂: opposite swings, spring working hard, higher frequency.

Any motion is a mix. x₁ = (q₁ + q₂)/2 and x₂ = (q₁ − q₂)/2. The starting positions and velocities decide how much of each mode is present.

A normal mode is a motion in which every part oscillates at the same frequency and passes through equilibrium at the same instant. A system with N degrees of freedom has N normal modes; some may have zero frequency if the system can slide or turn freely as a whole.

Worked example. L=1.0 m, m=0.20 kg, k=0.49 N/m, g=9.8 m/s²: ω1=9.8=3.13 rad/s and ω2=9.8+4.9=3.83 rad/s. The trap is k/m instead of 2k/m: in the opposite mode the spring is stretched by 2x.

Energy swapping: beats between oscillators

Pull pendulum 1 aside by a and release both from rest. Both modes are present equally, and

x1=acos⁡(ω2−ω12t)cos⁡ω‾t,x2=asin⁡(ω2−ω12t)sin⁡ω‾t

Pendulum 1’s swing dies away while pendulum 2’s grows. After t=π/(ω2−ω1) all the energy is in pendulum 2; after twice that it is back. Weak coupling means close frequencies and a slow swap.

Start in step or opposite and each pendulum keeps its own energy for ever (a single mode). Pull only the left one and the energy swaps across and back. Weaken the spring and the swap slows down.

“Energy flowing back and forth between the pendulums is a normal mode.” It is the opposite. In a normal mode nothing changes except the common oscillation: each pendulum keeps its own share of energy. The slow swapping is what you see when two modes with slightly different frequencies run together and beat. Start the pendulums in the exact shape of one mode (equal and opposite, say) and they never exchange energy.

6. More masses: chains, molecules and rings

The same method works for any number of masses: write m𝐱¨=−K𝐱, try 𝐱=𝐚cos⁡ωt, and solve det⁡(K−mω2I)=0. The eigenvalues give ω2, the eigenvectors the mode shapes. Results worth knowing:

System Normal frequencies
wall-k-m-k-m-k-wall k/m, 3k/m (outer springs k, middle k′: (k+2k′)/m)
two masses and one spring, free 0, k/μ with μ=m1m2/(m1+m2)
linear molecule m-M-m (like CO₂) 0, k/m, (k/m)(1+2m/M)
N beads on a string, fixed ends ωn=2ω0sin⁡nπ2(N+1)
N masses in a closed ring ωn=2ω0|sin⁡(nπ/N)|, including 0 and repeated values

Worked example. Three equal masses between walls on four springs: the matrix ω02(2−10−12−10−12) has eigenvalues (2−2)ω02, 2ω02, (2+2)ω02. The middle mode, (1,0,−1), keeps the centre mass still. As N grows, the chain’s modes become the standing waves of a continuous string: that is the bridge to lesson 3.4. The GATE Physics course treats general small oscillations with the Lagrangian method.

The same mathematics appears in electric circuits: two LC loops sharing a capacitor Cc have modes at 1/LC and 1/LC+2/LCc, with 1/Cc playing the role of the spring.

  • Linear, homogeneous equations obey superposition: solutions add.
  • Same-frequency SHMs add like arrows: A2=A12+A22+2A1A2cos⁡Δϕ; equal amplitudes give 2A1cos⁡(Δϕ/2).
  • Close frequencies give beats at |f1−f2| (not half of it), with the fast oscillation at the average.
  • Perpendicular SHMs make Lissajous figures: line, ellipse, circle for 1 : 1 as the phase grows; fy:fx = top touches : side touches; closed only for rational ratios.
  • Coupled pendulums: in step at g/L, opposite at g/L+2k/m. Normal coordinates x1±x2 decouple the equations.
  • Energy swaps between oscillators when two modes beat: full transfer after π/(ω2−ω1). A single mode never swaps energy.
  • N degrees of freedom give N modes, found from det⁡(K−mω2)=0; free systems have zero modes.

Practise: exam questions on this lesson

They start easy and climb to top-rank level. More on the superposition and coupled oscillators practice page.

Next: lesson 3.4 lets the number of coupled masses grow without limit, which turns normal modes into waves on a string. Before that, revisit simple harmonic motion if phasors felt new, and damped and forced oscillations for what friction does to each mode.

Go deeper: GATE’s small oscillations and normal modes does the general linear case, and CSIR NET’s nonlinear dynamics and chaos picks up when amplitudes are no longer small.

Check yourself

1Two identical pendulums are joined by a spring. In which normal mode does the spring play no part?
2A Lissajous figure touches the top of its box 3 times and a side 2 times. What is f_y : f_x?
3Two coupled pendulums have normal-mode frequencies 1.00 Hz and 1.02 Hz. One is set swinging, the other at rest. When is the first one still for the first time?

Sources

  • A. P. French, Vibrations and Waves, MIT Introductory Physics Series (1971), chapters 2 and 5
  • H. J. Pain and P. Rankin, Introduction to Vibrations and Waves (2015), chapters 1 and 4
  • H. Goldstein, C. Poole and J. Safko, Classical Mechanics, 3rd ed. (2002), chapter 6: small oscillations
  • IIT JAM Physics syllabus (Oscillations, Waves and Optics section), published by the organising IIT each year

Your ticks stay in this browser. Save them as a file on the course home.

Updated 2026-11-22. Not affiliated with IIT or the JAM organising institute. Exam pattern as published for recent years: always check the official JAM website before the exam. All questions are original.