Home / Learn / Exam prep / IIT JAM Physics / Lesson 4.3
All lessons

Module 4: Electricity and magnetism · Lesson 4.3 · about 45 min

Conductors, Laplace's equation and images

Conductors in equilibrium, surface charge and the pressure on it, cavities and screening, what Laplace's equation forbids, the uniqueness theorem, separation of variables in a slot, and the method of images for planes, corners and spheres, with the sphere in a uniform field.

Key points, meanings and formulas on one page: choose "Save as PDF" in the print box.

Module 4 · about 45 minutes. By the end you will know exactly what a conductor does to the field around it, why empty cavities are screened, what Laplace’s equation allows and forbids, why one solution is the only solution, and how to replace a grounded conductor by a few imaginary charges to get forces, energies and induced charges in a few lines.

A conductor rearranges its charge until the field inside it is zero; whatever field remains outside is fixed completely by the conductor's potential and the charges around it, so any trick that gets the boundary right gets everything right.

1. What a conductor does

A conductor is full of charges free to move. Put it in a field and they move until they feel no force. So, in electrostatic equilibrium:

  • inside the metal, E→=0 (otherwise charges would still be moving);
  • the whole conductor is one equipotential;
  • any net charge sits on the surface (Gauss’s law with a surface just inside the metal encloses nothing);
  • just outside, the field is perpendicular to the surface with size E=σ/ϵ0.

The last rule comes from a tiny pillbox through the surface: flux leaves only through the outer face, so EA=σA/ϵ0. Compare an isolated sheet of charge, σ/2ϵ0 on each side: a conductor has no field on its inside, so all the flux goes out on one side and the field is twice as strong.

Worked example. Where the surface charge density is 3.0 μC/m², E=3.0×10−68.854×10−12=3.39×105 V/m just outside.

Where does the charge go? On an isolated sphere it spreads evenly. On any other shape it crowds where the surface curves most. Two spheres joined by a wire share one potential kQ/R, so Q∝R and σ∝1/R: the small sphere has the denser charge and the stronger field. That is why charge leaks from sharp points (corona discharge) and why high-voltage domes are big and smooth: a sphere of radius R reaches the breakdown field of air, about 3×106 V/m, at V=Emax⁡R, only 150 kV for a 5 cm ball.

The push on the surface. A patch of charge feels the field of all the other charges, which is the average of the fields on its two sides, 12(σ/ϵ0+0). So the outward pressure is

P=σ22ϵ0=12ϵ0E2

outward whatever the sign of σ. A charged soap bubble swells.

E = 0 inside
the free charges have stopped moving, so nothing pushes them
σ
surface charge per square metre; it shows where field lines start or end on the metal
E = σ/ε₀ outside
all the flux from the surface charge goes outward, none into the metal
σ²/2ε₀
the outward pressure on a charged surface, equal to the field energy per volume just outside
Physical meaning
A conductor is a perfect field-cancelling machine. Its charges move to wherever they are needed to make the inside field-free, and the shape of the metal decides where they pile up.

2. Cavities and screening

Hollow out a conductor. Two cases:

  • An empty cavity. Its boundary is one equipotential and it contains no charge, so (by the uniqueness theorem below) V is constant inside and E=0. Charges outside, however large, cannot reach in. This is the Faraday cage: a car body protects you from lightning, and a metal box shields sensitive electronics.
  • A charge q inside the cavity. The cavity wall gets −q, arranged to cancel q’s field everywhere in the metal. A neutral conductor then carries +q on its outer surface, spread exactly as if the inside did not exist (uniformly, for a spherical outer surface). The outside sees the total charge, never where it is. Ground the conductor and the outer +q flows away: only then is the outside fully screened.

“A neutral metal shell hides a charge placed inside it.” It does not. The inner surface gets −q, so the outer surface must get +q, and outside the field is kq/r2 as if the shell were absent. A shell screens the inside from the outside (an empty cavity is field-free), but it only screens the outside from the inside when it is grounded.

3. Laplace’s equation and what it forbids

In any region with no charge, the potential obeys Laplace’s equation (lesson 4.2 derived Poisson’s equation ∇2V=−ρ/ϵ0):

∇2V=∂2V∂x2+∂2V∂y2+∂2V∂z2=0

Its solutions, called harmonic functions, have one beautiful property: the value at any point is the average over any sphere around it. Three consequences follow at once:

  1. V has no maximum or minimum inside a charge-free region; the extremes are on the boundary.
  2. Earnshaw’s theorem: no arrangement of static charges can hold a test charge in stable equilibrium, because that needs a minimum of qV.
  3. If V is constant on the boundary, it is that constant everywhere inside (the screened cavity).

Quick test. x2−y2, xy and excos⁡y are harmonic; x2+y2 is not (its Laplacian is 4, which needs charge density −4ϵ0).

4. The uniqueness theorem

If ρ is given inside a region and V is given on its whole boundary, there is only one solution.

Proof in two lines: if V1 and V2 both work, their difference obeys Laplace’s equation and is zero on the boundary, so (no maximum or minimum inside) it is zero everywhere. A second version replaces the boundary values by the total charge on each conductor.

This is what makes guessing legal. Any potential that satisfies Laplace’s equation in the region and matches the boundary is the answer, however you found it. The method of images is a way of guessing well.

5. The method of images

A charge above a grounded plane. A charge q sits at height d above an infinite grounded plate. We need V=0 on the plate and the charge q above it. Remove the metal and put an image −q at depth d: every point of the plane is equidistant from both, so V=0 there. Above the plane this is the right field, by uniqueness. (Below, the real field is zero: the image is a bookkeeping device, not a real charge.)

Field lines of a charge above a grounded plane all end on the metal, at right angles. Show the image to see them continue to a fictitious −q. The lower panel is the induced charge density; dotted lines mark the circle that holds half of it.

Everything follows from the two-charge picture:

Force. The charge is pulled towards its image, 2d away: F = kq²/(2d)² = kq²/4d².

Induced charge density. Just above the plate both charges give a downward field; σ = ε₀En = −qd / 2π(r² + d²)3/2, largest (−q/2πd²) right under the charge.

Total induced charge. Integrating σ over the plane gives exactly −q: every field line from q ends on the plate. Half of it lies within r = √3 d, so it is widely spread.

Energy. Bringing q in from infinity takes W = −kq²/4d: half of the two-real-charge value −kq²/2d, because only the upper half-space holds field, and the image moves as q moves.

Worked example. A 2.0 nC charge 10 cm above a grounded plate: F=(8.99×109)(2.0×10−9)2(0.20)2=0.90 μN, and the density right below it is −2.0×10−92π(0.10)2=−32 nC/m².

Corners. Two grounded planes at 90∘: a charge q at (a,b) needs three images, −q at (−a,b), −q at (a,−b) and +q at (−a,−b). For a wedge of angle θ with 360∘/θ=n an even integer, there are n−1 images with alternating signs round the circle (5 for 60∘, 7 for 45∘). For q at (a,a) in a right-angled corner, the net pull is (22−1)kq28a2 towards the corner: the positive image pushes back a little.

A grounded sphere. A charge q at distance d from the centre of a grounded sphere of radius R: the image is

q′=−qRd,placed at b=R2d from the centre

The sphere carries exactly q′. The force is kq2Rd(d2−R2)2, attractive. If the sphere is isolated and neutral instead, add +qR/d at the centre to bring its total back to zero; the force is still attractive (the negative image is nearer), only weaker. A neutral conductor always attracts a charge. And the potential of that isolated neutral sphere is simply kq/d: its potential equals the value at its centre, where the induced charges, all at distance R and summing to zero, contribute nothing.

“The image of a charge in a grounded sphere is −q, like in a plane.” Only for a plane. A sphere of radius R needs the smaller image −qR/d, inside the sphere at R2/d. As R and d grow with d−R fixed, −qR/d→−q and the plane result comes back.

6. A conducting sphere in a uniform field

Put a neutral metal ball of radius R in a uniform field E0zˆ. Separating Laplace’s equation in spherical coordinates (solutions rl and r−(l+1) times Legendre polynomials) gives

V=−E0(r−R3r2)cos⁡θ,σ=3ϵ0E0cos⁡θ

The second term is a dipole of moment p=4πϵ0R3E0. The field just outside is 3E0 at the poles and zero at the equator: the ball gathers field lines towards itself. The total induced charge is zero; it only separates.

Separation of variables in a slot. Grounded walls at y=0 and y=a, the end x=0 held at V0: the solution is V=∑n odd4V0nπe−nπx/asin⁡nπya. Far from the end only n=1 survives, dying away over a length a/π. One slot width in, only about 5% of V0 is left. The 2D electrostatics solver solves Laplace’s equation numerically for any electrodes you draw, and in the field line plotter you can place a charge and its image yourself and watch the midplane become an equipotential.

  • In a conductor E=0, V is constant, charge is on the surface, and just outside E=σ/ϵ0 normal to it. Pressure on the surface σ2/2ϵ0, outward.
  • Charge crowds onto sharp points: joined spheres have σ∝1/R. Sphere at breakdown: V=Emax⁡R.
  • Empty cavity: E=0. Charge in a cavity: −q on the inner wall, +q on the outer surface (spread as if the inside were absent) unless grounded.
  • Harmonic functions: mean value property, no maxima or minima, Earnshaw. Uniqueness: match the boundary and you have the solution.
  • Plane: image −q at depth d; force kq2/4d2; σmax⁡=−q/2πd2; total −q; work −kq2/4d. Wedge of 360∘/n: n−1 images.
  • Grounded sphere: q′=−qR/d at R2/d; isolated neutral: add +qR/d at the centre. Sphere in E0: σ=3ϵ0E0cos⁡θ, p=4πϵ0R3E0.

Practise: exam questions on this lesson

These start easy and climb to top-rank level. Check each answer, then read the full solution. More on the conductors and images practice page.

Next: dielectrics and capacitors puts insulators between the conductors. Back to the potential and Poisson’s equation: potential and electrostatic energy. For multipole expansions and harder boundary value problems at MSc level, see the GATE Physics course.

Check yourself

1A charge q is held at height d above a large grounded metal plate. What is the force on it?
2An empty cavity inside a neutral metal block. A big charge is brought near the outside. What is the field in the cavity?
3Two metal spheres of radii 1 cm and 4 cm are joined by a long wire. What is the ratio of their surface charge densities (small to large)?

Sources

  • D. J. Griffiths, Introduction to Electrodynamics, 4th ed. (2017), chapters 2.5 and 3
  • E. M. Purcell and D. J. Morin, Electricity and Magnetism, 3rd ed. (2013), chapter 3
  • J. D. Jackson, Classical Electrodynamics, 3rd ed. (1999), chapters 1 and 2 (for the uniqueness theorem and images)
  • IIT JAM Physics syllabus (Electricity and Magnetism section), published by the organising IIT each year

Your ticks stay in this browser. Save them as a file on the course home.

Updated 2026-11-22. Not affiliated with IIT or the JAM organising institute. Exam pattern as published for recent years: always check the official JAM website before the exam. All questions are original.