Home / Learn / Exam prep / IIT JAM Physics / Lesson 3.2
All lessons

Module 3: Oscillations, waves and optics · Lesson 3.2 · about 45 min

Damped and forced oscillations, resonance

How friction makes oscillations die away, what the logarithmic decrement and the quality factor Q measure, and how a driven oscillator responds: steady-state amplitude and phase, amplitude and power resonance, bandwidth and the LCR analogy.

Key points, meanings and formulas on one page: choose "Save as PDF" in the print box.

Module 3 · about 45 minutes. By the end you will be able to tell under-, critical and over-damping apart from the equation, use the logarithmic decrement and Q to describe energy loss, write down the steady-state amplitude and phase of a driven oscillator, and explain why displacement resonance, velocity resonance and the half-power width are three slightly different things.

Friction makes an oscillator forget how it started; a periodic push then decides everything, and the response is huge only when the push keeps time with the oscillator's own rhythm.

1. Adding friction

Real oscillators lose energy. The simplest model, good for motion through air or oil at low speed, is a drag force proportional to velocity, −bx˙. Adding it to the spring of lesson 3.1:

mx¨+bx˙+kx=0⟺x¨+2βx˙+ω02x=0,β=b2m,  ω0=km

We will use β (units s⁻¹) as the damping rate throughout. Some books write γ=b/m=2β; always check which one a question uses, because examiners exploit the factor 2.

Try x=est: s2+2βs+ω02=0, so s=−β±β2−ω02. Everything depends on which is bigger, β or ω0:

Case Condition Motion
Underdamped β<ω0 x=Ae−βtcos⁡(ωdt+ϕ) with ωd=ω02−β2: oscillates inside a shrinking envelope
Critically damped β=ω0 (b2=4mk) x=(C1+C2t)e−ω0t: fastest return without overshoot
Overdamped β>ω0 sum of two decaying exponentials: creeps back, crosses zero at most once

Note that ωd<ω0: damping makes each swing take longer.

Worked example. A 0.2 kg mass on a spring with k=80 N/m has b=0.8 kg/s. Then ω0=400=20 rad/s and β=0.8/0.4=2 s⁻¹. Since β<ω0 it is underdamped, with ωd=400−4=19.90 rad/s, barely below ω0. Light damping hardly changes the frequency; it mainly makes the amplitude decay.

2. Measuring damping: decrement, relaxation time and Q

For the underdamped case, successive maxima on the same side are one period Td apart, so their ratio is always the same:

xnxn+1=eβTd,δ=ln⁡xnxn+1=βTd(logarithmic decrement)

Energy goes as amplitude squared, so it decays as e−2βt: the energy falls by e in the relaxation time τ=1/(2β)=m/b, twice as fast as the amplitude.

The quality factor packs all this into one number:

Q=ω02β=mkb≈2πenergy storedenergy lost per cycle
β = b/2m
how fast the amplitude dies away: it falls by a factor e in 1/β seconds
δ = βT
the natural log of the ratio of one peak to the next
τ = m/b
the time for the stored energy to fall by a factor e
Q = ω₀/2β
roughly π times the number of swings before the amplitude falls by e
Physical meaning
A tuning fork (Q of thousands) rings for many seconds; a car's shock absorber (Q below 1) stops the bounce at once. Q is the one number that says which kind of oscillator you have.

Worked example. A pendulum’s amplitude falls from 6.0 cm to 4.5 cm in 5 complete swings. Then δ=ln⁡(6/4.5)/5=0.2877/5=0.0575 per swing. Since δ=βT≈π/Q for light damping, Q≈π/0.0575≈55. Its energy halves when the amplitude reaches 6/2=4.24 cm, not 3 cm.

3. Driving it: the steady state

Now push the oscillator with a periodic force F0cos⁡ωt:

x¨+2βx˙+ω02x=F0mcos⁡ωt

The full solution is a transient (the free damped motion, which dies away as e−βt and carries all memory of how you started) plus a steady state at the driving frequency. Here is the quickest way to the steady state:

Go complex. Replace cos ωt by eiωt and look for x = à eiωt, with à a complex number. Take the real part at the end.

Derivatives become multiplications. d/dt gives a factor iω, so the equation becomes (ω₀² − ω² + 2iβω) Ã = F₀/m.

Solve for Ã. Ã = (F₀/m) / (ω₀² − ω² + 2iβω): a complex number with a size and an angle.

The size is the amplitude. A = (F₀/m) / √((ω₀² − ω²)² + 4β²ω²).

The angle is the lag. x = A cos(ωt − φ) with tan φ = 2βω/(ω₀² − ω²), between 0 and π: the response always lags the force.

A(ω)=F0/m(ω02−ω2)2+4β2ω2,tan⁡ϕ=2βωω02−ω2

Check the limits, which examiners love to ask:

  • ω→0: A→F0/k (the static stretch), ϕ→0. The spring dominates.
  • ω=ω0: A=F0/(2mβω0)=QF0/k, ϕ=π/2. The damper dominates.
  • ω≫ω0: A≈F0/(mω2), ϕ→π. The mass dominates; it moves against the force.

Worked example. A 0.5 kg mass, k=200 N/m (ω0=20 rad/s), b=2 kg/s (β=2 s⁻¹), driven by 4cos⁡16t N.

  1. F0/m=8 m/s²; ω02−ω2=400−256=144; 2βω=64.
  2. A=8/1442+642=8/157.6=0.051 m.
  3. tan⁡ϕ=64/144=0.444, so the displacement lags by 24.0∘.

4. Resonance: three peaks that are almost the same

Move the sliders below. The amplitude curve rises to a peak and the phase swings from 0 to 180°; the sharper the peak, the higher the Q.

Top: amplitude (solid) and absorbed power (dashed, scaled to the same height at ω₀). Bottom: how far the displacement lags the force. Low Q: no peak at all. High Q: a tall, narrow spike at ω₀.

There are three “resonances”, and JAM asks you to keep them apart:

What is largest Where Value
Displacement amplitude ωr=ω02−2β2 (exists only if Q>1/2) F0/(2mβω02−β2)
Velocity amplitude and absorbed power exactly ω0, for any damping v0=F0/b, ⟨P⟩=F02/(2b)
Free oscillation frequency (not a resonance) ωd=ω02−β2

So ωr<ωd<ω0. For light damping all three are almost equal, which is why textbooks often blur them; at Q≈1 they are clearly different.

Bandwidth. The power curve falls to half its peak at two frequencies whose difference is exactly Δω=2β. Hence

Q=ω0Δω=f0Δf

At those half-power points the phase lag is exactly 45∘ and 135∘.

Worked example. For the oscillator above (ω0=20, β=2, F0=4 N, b=2 kg/s): Q=20/4=5; the half-power band is Δω=4 rad/s wide; the power at resonance is F02/(2b)=16/4=4 W; the amplitude peaks at 400−8=19.80 rad/s with height 8/(4396)=0.1005 m, a hair above the 0.1000 m reached at ω0.

“At resonance the displacement is in phase with the force.” It is not: at ω=ω0 the displacement lags by exactly 90∘. It is the velocity that is in phase with the force, which is exactly the condition for the force to do the most work. Think of pushing a child on a swing: you push hardest as the swing passes the bottom moving away from you (fastest), not when it is furthest away.

5. Energy in the steady state

In the steady state the driver’s work per cycle exactly replaces what the damper burns:

Wcycle=∮bx˙2dt=πbωA2

The time-averaged kinetic energy is 14mω2A2 and the potential energy 14kA2: they are equal only at ω=ω0. Below resonance the spring holds more energy, above it the mass does.

6. The same equation everywhere

A series LCR circuit with an AC source obeys Lq¨+Rq˙+q/C=ℰ0cos⁡ωt. Match term by term: m→L, b→R, k→1/C, F0→ℰ0. So ω0=1/LC and Q=(1/R)L/C, and current resonance at ω0 is the velocity resonance above.

Worked example. L=20 mH, C=2 μF, R=5 Ω: ω0=1/4×10−8=5000 rad/s and Q=15104=20.

The Forced oscillations tool lets you watch the transient die and the steady state take over, and LCR phasors shows the electrical version as rotating arrows. When two oscillators are joined, energy sloshes between them: try the Coupled oscillators simulation before lesson 3.3.

Dry friction is different. A block sliding on a rough floor feels a force of fixed size μmg. Each half-swing is then SHM about a shifted centre, and the amplitude falls by the same amount, 4μmg/k, every cycle (linear decay), until a turning point lands where the spring cannot beat static friction. Equal ratios mean viscous damping; equal differences mean dry friction.

  • mx¨+bx˙+kx=0: underdamped if b2<4mk (β<ω0), critical if equal, overdamped if greater. ωd=ω02−β2, a little below ω0.
  • Amplitude decays as e−βt, energy as e−2βt. Decrement δ=βTd; relaxation time τ=m/b.
  • Q=ω0/2β=mk/b=f0/Δf≈2πE/ΔEcycle.
  • Steady state: A=(F0/m)/(ω02−ω2)2+4β2ω2, tan⁡ϕ=2βω/(ω02−ω2); limits F0/k, QF0/k, F0/mω2.
  • Velocity and power resonance at exactly ω0 (phase 90∘); displacement peak at ω02−2β2, only if Q>1/2. Half-power width 2β, phases 45∘ and 135∘ there.
  • LCR: m→L, b→R, k→1/C. Dry friction gives a linear, not exponential, decay.

Practise: exam questions on this lesson

They start easy and climb to top-rank level. More on the damped and forced oscillations practice page.

Next: lesson 3.3 adds oscillations together (beats, Lissajous figures and coupled oscillators), and lesson 3.4 lets the oscillation travel as a wave. In electronics, resonance reappears in filters and oscillator circuits, which the GATE Physics course covers in its electronics module.

Check yourself

1An oscillator is driven exactly at its natural frequency ω₀. What is the phase of its displacement relative to the driving force?
2Two successive maxima of a damped oscillation are 10 mm and 9 mm. What happens to the ratio of the next two?
3What does a quality factor Q = 100 tell you about an oscillator?

Sources

  • A. P. French, Vibrations and Waves, MIT Introductory Physics Series (1971), chapters 3 and 4
  • H. J. Pain and P. Rankin, Introduction to Vibrations and Waves (2015), chapters 2 and 3
  • D. Kleppner and R. Kolenkow, An Introduction to Mechanics, 2nd ed. (2014), chapter 6
  • IIT JAM Physics syllabus (Oscillations, Waves and Optics section), published by the organising IIT each year

Your ticks stay in this browser. Save them as a file on the course home.

Updated 2026-11-22. Not affiliated with IIT or the JAM organising institute. Exam pattern as published for recent years: always check the official JAM website before the exam. All questions are original.