Home / Learn / Exam prep / IIT JAM Physics / Lesson 7.2
All lessons

Module 7: Solid state physics and electronics · Lesson 7.2 · about 45 min

X-ray diffraction and Bragg's law

Why crystals reflect X-rays only at special angles, Bragg's law and the Laue condition, the structure factor and why some reflections go missing in bcc, fcc and diamond, and how to index a powder pattern to find the lattice constant.

Key points, meanings and formulas on one page: choose "Save as PDF" in the print box.

Module 7 · about 45 minutes. By the end you will be able to use Bragg’s law in both directions, explain why a crystal reflects only at certain angles, predict which reflections a structure allows, and turn a list of powder-pattern angles into a crystal structure and a lattice constant. You need Miller indices and dhkl from lesson 7.1.

A crystal is a three-dimensional diffraction grating. X-rays bounce off every plane of atoms, and only at angles where all those reflections arrive in step does a bright beam come out.

1. Why X-rays?

To see a grating, you need light with a wavelength similar to its spacing. Atomic planes are 1 to 5 Å apart. Visible light, at 4000 to 7000 Å, is a thousand times too long: no angle would work. X-rays from a copper target (λ=1.54 Å) or a molybdenum target (0.71 Å) are just right. Electrons and neutrons work too, because they have de Broglie wavelengths:

λelectron=h2meeV≈12.26V Å,λneutron=h2mnE≈1.8 Å at 0.025 eV

Electrons are scattered strongly (good for thin films and surfaces); neutrons see light atoms such as hydrogen and the magnetic order of spins.

2. Bragg’s law

W. L. Bragg pictured the crystal as a stack of partly reflecting mirrors, the atomic planes, a distance d apart. A ray reflecting from the second plane travels further than one reflecting from the first. The extra distance is dsin⁡θ on the way in plus dsin⁡θ on the way out, where θ is the glancing angle between the ray and the planes. The reflections add up only when this extra path is a whole number of wavelengths:

2dsin⁡θ=nλ,n=1,2,3,…
The coloured segment is the extra path 2d sin θ. Slide θ: the graph below shows that a stack of 12 planes reflects strongly only near the Bragg angles, where the extra path is a whole number of wavelengths. More planes make the peaks sharper.
d
the spacing of one family of parallel planes, dhkl
θ
the glancing angle, measured from the planes, not from their normal; the beam is turned through 2θ
n
the order of reflection: how many whole wavelengths the extra path holds
Physical meaning
Each plane reflects only a tiny fraction of the beam, but thousands of planes reflecting in step build a strong beam. One wavelength off at the thousandth plane, and they cancel. That is why Bragg peaks are sharp.

Two consequences you must know:

  • A largest wavelength. Since sin⁡θ≤1, reflection needs λ≤2d, and the highest order is the whole number part of 2d/λ.
  • Higher orders are just other planes. 2dsin⁡θ=2λ is the same as 2(d/2)sin⁡θ=λ, and dhkl/2=d2h2k2l. So the second order from (111) is written as (222), and in cubic crystals we usually set n=1 and let the indices carry the order:
sin2⁡θ=λ24a2(h2+k2+l2)

Worked example. Copper (fcc, a=3.61 Å) is studied with λ=1.54 Å. Find the angle of the (111) reflection.

  1. d111=3.61/3=2.084 Å.
  2. sin⁡θ=1.54/(2×2.084)=0.3694, so θ=21.7∘.
  3. The diffractometer shows the peak at 2θ=43.4∘. Putting 43.4∘ into Bragg’s law is the most common mistake in this topic.

3. The Laue picture and the Ewald sphere

The same condition, seen in reciprocal space (lesson 7.1, section 6): an incident wave k→ scatters elastically into k→′ with |k→′|=|k→|=2π/λ, and the scattered waves from all lattice points add in step only when

k→′−k→=G→(Laue condition)

where G→ is a reciprocal lattice vector. Because |G→hkl|=2π/dhkl and |k→′−k→|=2ksin⁡θ, this is exactly Bragg’s law. Ewald’s construction draws a sphere of radius 2π/λ: a beam comes out whenever a reciprocal lattice point lies on the sphere. For a fixed crystal and one wavelength that rarely happens, which is why there are three experimental methods:

Method Beam Sample What varies
Laue white (all wavelengths) fixed single crystal λ: each plane picks its own; used to find orientation and symmetry
Rotating crystal one wavelength single crystal turned θ
Powder (Debye-Scherrer) one wavelength fine powder θ: some grain always has the right angle; rings or peaks

4. Why some reflections are missing: the structure factor

Bragg’s law says where a reflection could be. Whether it actually appears depends on what is inside the cell. Each atom j at fractional position (xj,yj,zj) scatters a wave with phase 2π(hxj+kyj+lzj). Adding them gives the structure factor:

Fhkl=∑jfje2πi(hxj+kyj+lzj),Ihkl∝|Fhkl|2

fj is the atomic form factor: equal to the number of electrons Z in the forward direction, falling at higher angles.

Worked example (bcc). Identical atoms at (0,0,0) and (12,12,12):

  1. F=f[1+eiπ(h+k+l)].
  2. If h+k+l is even, eiπ⋅even=1 and F=2f.
  3. If it is odd, F=f(1−1)=0: the reflection vanishes.

In plain words: for (100) the body-centre atoms form a plane exactly halfway between the cube faces, and their reflection is half a wavelength out of step. They cancel the face reflection perfectly.

Structure Allowed (hkl) First lines (h2+k2+l2)
Simple cubic all 1, 2, 3, 4, 5, 6, 8, 9 (7 is impossible)
bcc h+k+l even 2, 4, 6, 8, 10, 12, 14, 16
fcc all odd or all even 3, 4, 8, 11, 12, 16, 19, 20
Diamond all odd, or all even with h+k+l=4m 3, 8, 11, 16, 19, 24

With two kinds of atom, lines weaken rather than vanish. In CsCl, F=fCs±fCl: all simple cubic lines appear, the odd ones weak. In rock salt, F=4(f++f−) for all even and 4(f+−f−) for all odd. In KCl the two ions both have 18 electrons, the odd lines all but disappear, and the pattern masquerades as simple cubic with half the real cube edge.

“A missing reflection means those planes are not there.” The planes are there; their reflection is cancelled by extra atoms lying between them, exactly out of step. Missing reflections are not a nuisance but a fingerprint: they tell bcc from fcc from diamond, and the strength of the weak lines in CsCl or an ordered alloy measures the difference between the atoms.

5. Indexing a powder pattern

Here is the procedure for a cubic crystal, the most common exam task:

Halve the angles. Convert each peak position 2θ into θ.

Square the sines. Work out sin²θ for each line. They are proportional to h² + k² + l².

Divide by the first. Ratios 1 : 2 : 3 : 4 : 5 : 6 : 8 mean simple cubic; 1 : 2 : 3 : 4 : 5 : 6 : 7 : 8 (that is, 2 : 4 : 6 : ...) mean bcc; 3 : 4 : 8 : 11 means fcc; 3 : 8 : 11 : 16 means diamond.

Assign indices. Match each line to its allowed (hkl).

Get the lattice constant. a = λ√(h² + k² + l²) / (2 sin θ), from any line (high-angle lines give the best accuracy).

Worked example. A cubic powder with λ=1.54 Å shows its first two lines at θ=21.68∘ and 25.25∘.

  1. sin2⁡θ=0.1365 and 0.1820: ratio 1.333=4/3.
  2. The first two lines in the ratio 3:4 are (111) and (200): fcc. (sc and bcc both start 1:2.)
  3. a=1.543/(2×0.3694)=3.61 Å.

A trap: simple cubic and bcc have the same ratios for the first six lines. Only the seventh decides, because no sum of three squares equals 7.

6. What else the peaks tell you

  • Peak shift. Differentiating Bragg’s law, Δd/d=−cot⁡θΔθ. Expansion moves peaks to lower angle, and high-angle peaks move most, so precise lattice constants use back-reflection peaks.
  • Peak width. Small crystallites broaden peaks (Scherrer: τ=Kλ/(βcos⁡θ), with K≈0.9 and β the width in radians of 2θ). Strain broadens them too; the Williamson-Hall plot of βcos⁡θ against sin⁡θ separates the two (intercept: size, slope: strain).
  • Temperature. Thermal vibration lowers peak heights by the Debye-Waller factor e−2W, more at high angles, and adds a diffuse background, but leaves the peaks sharp.

Worked example (Scherrer). A peak at 2θ=40∘ with λ=0.154 nm is 0.50∘ wide. β=0.50×π/180=8.73×10−3 rad, so τ=0.9×0.154/(8.73×10−3×cos⁡20∘)=16.9 nm.

Real patterns are easy to try: the XRD peak calculator turns peak positions into d-spacings and crystallite sizes, the electron diffraction indexer does the same for TEM patterns, and the Lattice FFT shows how a microscope image of a lattice turns into a diffraction-like spot pattern. Diffraction by slits and gratings, the optics behind all of this, is in lesson 3.8.

  • Bragg: 2dsin⁡θ=nλ, with θ the glancing angle (half the detector angle 2θ). Needs λ≤2d.
  • n-th order from (hkl) = first order from (nhnknl). Cubic: sin2⁡θ∝h2+k2+l2.
  • Laue condition k→′−k→=G→ is Bragg’s law in reciprocal space; methods: Laue (white beam), rotating crystal, powder.
  • Structure factor F=∑fje2πi(hxj+kyj+lzj), intensity ∝|F|2.
  • bcc: h+k+l even; fcc: unmixed; diamond: fcc rule and no h+k+l=4m+2 for all-even.
  • Index powder lines by sin2⁡θ ratios: sc 1:2:3:4:5:6:8, bcc 2:4:6:8, fcc 3:4:8:11, diamond 3:8:11:16.
  • Electron λ≈12.26/V Å; Scherrer τ=Kλ/(βcos⁡θ).

Practise: exam questions on this lesson

They start easy and climb to top-rank level. Check each answer, then read the full solution. There are more on the X-ray diffraction practice page.

Next: lesson 7.3 moves from where the atoms are to what their electrons do: bands, gaps and the Fermi level. The GATE Physics course takes diffraction further, with the full structure factor algebra and neutron scattering.

Check yourself

1A diffractometer shows a peak at 2θ = 40° with λ = 1.54 Å. Which angle goes into Bragg's law?
2Which reflection is the first (lowest-angle) line of a bcc metal?
3The first powder lines of a cubic crystal have sin²θ in the ratio 3 : 4 : 8 : 11. What is the structure?

Sources

  • C. Kittel, Introduction to Solid State Physics, 8th ed. (2005), chapter 2
  • B. D. Cullity and S. R. Stock, Elements of X-Ray Diffraction, 3rd ed. (2014), chapters 3 and 4
  • N. W. Ashcroft and N. D. Mermin, Solid State Physics (1976), chapter 6
  • IIT JAM Physics syllabus (Solid State Physics, Devices and Electronics section), published by the organising IIT each year

Your ticks stay in this browser. Save them as a file on the course home.

Updated 2026-11-22. Not affiliated with IIT or the JAM organising institute. Exam pattern as published for recent years: always check the official JAM website before the exam. All questions are original.