Home / Learn / Exam prep / IIT JAM Physics / Lesson 4.8
All lessons

Module 4: Electricity and magnetism · Lesson 4.8 · about 50 min

DC transients and AC circuits

RC and RL charging and decay with the energy bookkeeping examiners love, LC oscillations, damped LCR circuits (under-, critically and overdamped), reactance and impedance with phasors, series and parallel resonance, Q and bandwidth, rms values, power factor and maximum power transfer.

Key points, meanings and formulas on one page: choose "Save as PDF" in the print box.

Module 4 · about 50 minutes. By the end you will be able to write down any RC or RL transient in one line, track where the energy goes, classify a free LCR circuit as under-, critically or overdamped, draw phasor diagrams, find impedance, phase, resonance, Q, bandwidth and average power, and match a load for maximum power.

Capacitors resist sudden changes of voltage and inductors resist sudden changes of current; every transient is the circuit relaxing exponentially to its new steady state, and every AC circuit is the same idea run at one frequency, where L and C become frequency-dependent resistances.

1. RC circuits

A battery V0 charges a capacitor C through R. Kirchhoff’s loop rule gives V0=IR+q/C with I=dq/dt, a first-order equation:

VC(t)=V0(1−e−t/τ),I(t)=V0Re−t/τ,τ=RC

Discharging from V0: VC=V0e−t/τ. After one τ a charging capacitor is at 63%, after 5τ past 99%; a discharging one halves in τln⁡2. At the instant of switching an uncharged capacitor acts as a wire; after a long time it acts as a break.

Short cut for any RC circuit with one capacitor. Replace the rest of the circuit, as the capacitor sees it, by its Thevenin equivalent Vth, Rth. Then VC goes exponentially from its start value to Vth with τ=RthC. Example: 12 V through 2 kΩ, with 4 kΩ across a 3 µF capacitor: Vth=8 V, Rth=1.33 kΩ, τ=4 ms.

Charging and discharging curves of an RC or RL circuit. Change R and C (or L) to see τ change, and move the probe in units of τ. The dashed curve is the stored energy, which moves twice as fast on decay.

Energy bookkeeping. Charging from zero, the battery delivers QV0=CV02, the capacitor stores 12CV02, and ∫I2Rdt=12CV02 is heat, independent of R. Joining a charged capacitor to an identical empty one loses 14CV2, again for any R. Because energy goes as V2, a discharging capacitor’s energy halves at 12τln⁡2, and a charging one reaches half its final energy only at 1.23τ.

2. RL circuits

Switch a battery onto R and L in series: V0=IR+LdI/dt, so

I(t)=V0R(1−e−t/τ),τ=LR

At t=0+ the current is zero and the whole V0 sits across the inductor; after a long time the inductor is a plain wire. Short out the battery and I=I0e−t/τ, the energy 12LI02 turning into heat. (Lesson 4.7 on induction covered this in detail.)

Worked example. 10 V, 100 Ω, 0.50 H: τ=5 ms, I∞=100 mA, and at 10 ms I=100(1−e−2)=86.5 mA.

3. LC and LCR: free oscillations

Connect a charged capacitor across an inductor. Lq¨+q/C=0: simple harmonic motion with ω0=1/LC. Energy sloshes between 12q2/C and 12LI2 (each oscillating at 2ω0), so Imax⁡=V0C/L. A 4 µF capacitor at 50 V into 1 mH gives Imax⁡=3.16 A.

Add resistance: Lq¨+Rq˙+q/C=0, the damped oscillator of lesson 3.2 with γ=R/2L:

Condition Behaviour
R<2L/C (underdamped) oscillates at ωd=ω02−R2/4L2, amplitude ∝e−Rt/2L
R=2L/C (critical) fastest return to zero without overshoot
R>2L/C (overdamped) slow creep back, no oscillation

Worked example. L=0.20 H and C=5.0 µF: critical at R=24×104=400 Ω. With L=1 H, C=1 µF and R=200 Ω: ωd=106−104=995 rad/s, just below ω0.

4. AC: reactance, impedance and phasors

With a sinusoidal source, every voltage and current oscillates at the same ω and differs only in size and phase. Represent each as an arrow (phasor) rotating at ω, or as a complex number (lesson 1.9 on complex numbers):

Element Impedance Phase of current
R R in phase with V
L jωL (reactance XL=ωL) lags by 90∘
C 1/(jωC) (reactance XC=1/ωC) leads by 90∘

Impedances combine like resistances. For R, L, C in series:

Z=R2+(XL−XC)2,tan⁡ϕ=XL−XCR

with the current lagging the voltage by ϕ (leading if ϕ<0). The component voltages add as phasors, not as numbers: with VR=30, VL=80, VC=40 V, the source is 302+402=50 V, not 150 V.

X_L = ωL
an inductor opposes fast changes, so its "resistance" grows with frequency
X_C = 1/ωC
a capacitor passes fast changes easily, so its "resistance" falls with frequency
Z
the ratio of voltage to current amplitude, combining R with the net reactance at right angles
φ
how far the current lags the voltage; positive for an inductive circuit
Physical meaning
L and C store energy and give it back each cycle; only R takes energy away for good. The phase angle measures how much of the current is just sloshing energy back and forth.

5. Resonance, Q and bandwidth

At ω0=1/LC, XL=XC: the series impedance is just R, the current peaks at V/R and is in phase with the source, and VL, VC cancel. Each of them alone is Q times the source voltage, where

Q=ω0LR=1RLC=ω0Δω,Δω=RL

Δω is the full width between the half-power points, where |XL−XC|=R. Those points are ω±=ω02+(R/2L)2±R/2L: their product is ω02, so they are symmetric about ω0 on a log scale.

The phasor diagram of a series LCR circuit above its resonance curve. Below resonance V_C wins and the current leads; above, V_L wins and it lags; at resonance V_L and V_C cancel and each is Q times the source.

Two facts that catch people: driven at resonance, the total stored energy is constant (it just moves between L and C while the source feeds the resistor), and the capacitor voltage peaks slightly below ω0 (the inductor’s slightly above), while current and power peak exactly at ω0.

Parallel resonance. An ideal L and C in parallel at ω0 have infinite impedance: their currents cancel and the source supplies nothing while current circulates round the loop. With a coil of resistance R in parallel with C, unity power factor comes at ω=1/LC−R2/L2.

“At resonance the capacitor and inductor voltages cancel, so they are small.” They cancel each other, but each is Q times the source. A 2 V signal into a circuit with Q=50 puts 100 V across the capacitor. That is how a radio tuner magnifies a weak station, and why capacitors in resonant circuits must be rated far above the supply voltage.

6. Power in AC circuits

For a sine wave, Vrms=V0/2 (311 V peak mains is 220 V rms). Only resistance absorbs power on average:

⟨P⟩=VrmsIrmscos⁡ϕ=Irms2R

cos⁡ϕ=R/Z is the power factor: 1 at resonance, 0 for a pure L or C. With R=100 Ω on 200 V rms, the power is 400 W at resonance but 200 W where |XL−XC|=100 Ω (a half-power point). For a mixed waveform v=a+bsin⁡ωt, Vrms=a2+b2/2.

Maximum power transfer. A source of internal resistance r gives most power to a load RL=r: Pmax⁡=V2/4r, at 50% efficiency. With a complex source impedance Zs, the load must be its complex conjugate Zs∗ so the reactances cancel: for Zs=30+40j Ω at 100 V, Pmax⁡=1002/120=83.3 W.

The circuit simulator runs transients and AC sweeps of any RLC netlist, the analog filter designer builds RC and LC filters from these ideas, and the capacitor inductor calculator gives RC and RL time constants.

  • RC: τ=RC, VC=V0(1−e−t/τ); RL: τ=L/R. Half-life τln⁡2; energy decays twice as fast. Use Thevenin for one-capacitor circuits.
  • Charging from a battery always wastes half the energy; sharing between equal capacitors loses 14CV2, whatever R.
  • LC: ω0=1/LC, Imax⁡=V0C/L. LCR critical at R=2L/C; ωd=ω02−R2/4L2.
  • XL=ωL (current lags), XC=1/ωC (current leads), Z=R2+(XL−XC)2, tan⁡ϕ=(XL−XC)/R; voltages add as phasors.
  • Resonance: Z=R, in phase, VL=VC=QV; Q=ω0L/R=ω0/Δω, Δω=R/L. Parallel LC: infinite impedance.
  • ⟨P⟩=VrmsIrmscos⁡ϕ=I2R; Vrms=V0/2. Max power: RL=r (or ZL=Zs∗), P=V2/4r.

Practise: exam questions on this lesson

These start easy and climb to top-rank level. Check each answer, then read the full solution. More on the circuits practice page.

Next: Maxwell’s equations and electromagnetic waves, where the displacement current between capacitor plates completes the theory. The mechanical twin of the LCR circuit is in damped and forced oscillations. Op-amp circuits are in operational amplifiers. For network theorems and transmission lines at MSc level, see the GATE Physics course, from amplifiers and feedback to waveguides.

Check yourself

1A capacitor is charged from a battery through a resistor. What fraction of the battery's energy ends up stored in the capacitor?
2In a series LCR circuit driven above its resonant frequency, how is the current related to the source voltage?
3At resonance, a series LCR circuit with Q = 20 is driven by 1 V rms. What is the rms voltage across the capacitor?

Sources

  • E. M. Purcell and D. J. Morin, Electricity and Magnetism, 3rd ed. (2013), chapters 4 and 8
  • D. J. Griffiths, Introduction to Electrodynamics, 4th ed. (2017), chapter 7.2 (RL circuits and energy)
  • H. C. Verma, Concepts of Physics, Part 2 (1993), chapters 32 and 39
  • IIT JAM Physics syllabus (Electricity and Magnetism section), published by the organising IIT each year

Your ticks stay in this browser. Save them as a file on the course home.

Updated 2026-11-22. Not affiliated with IIT or the JAM organising institute. Exam pattern as published for recent years: always check the official JAM website before the exam. All questions are original.