All lessons

Module 23: Alternating current · Lesson 23.1 · about 32 min

Alternating current

Peak, rms and average values, R, L and C on AC with reactance and phase, phasors, series LCR circuits, impedance, resonance, Q factor and bandwidth, power and power factor, wattless current, LC oscillations and the transformer with transmission losses.

Key points, meanings and formulas on one page: choose "Save as PDF" in the print box.

Physics · Class 12 · about 32 minutes. By the end you will be able to find currents, phases and power in any series AC circuit, use resonance, and solve LC and transformer problems.

On AC, resistors fight current in step with the voltage, while inductors and capacitors fight it a quarter cycle out of step. Draw each voltage as a rotating arrow (a phasor), add the arrows, and every series AC circuit becomes a right-angled triangle.

1. Peak, rms and average

AC voltage v=V0sin⁡ωt, with ω = 2πf. Indian mains: f = 50 Hz.

  • rms value (the steady DC value that heats a resistor equally): Vrms=V0/2 for a sine wave. Meters read rms.
  • Average over a full cycle: zero. Over half a cycle: 2V0/π≈0.637V0.
  • Other waves: square wave rms = peak; triangular wave rms = V0/3; half-wave rectified rms = V₀/2.

“AC current averages to zero, so it cannot heat anything.” Heating goes as I², which is never negative. The average of I² is I₀²/2, so AC heats just like a DC current of I₀/√2.

2. R, L and C on AC

Element Opposition Phase of current
Resistor R in phase with V
Inductor XL=ωL lags V by 90°
Capacitor XC=1ωC leads V by 90°

X_L grows with frequency (an inductor blocks high frequencies); X_C falls with frequency (a capacitor blocks DC completely and passes high frequencies). A handy memory: ELI the ICE man: in L, E (voltage) comes before I; in C, I comes before E.

3. Series LCR: impedance and phase

The same current flows through all three. Their voltages are phasors at right angles: V_R along I, V_L 90° ahead, V_C 90° behind. Adding them:

V=VR2+(VL−VC)2,Z=R2+(XL−XC)2,tan⁡φ=XL−XCR
Z
impedance, the total opposition (Ω); I_rms = V_rms/Z
φ
phase angle by which the current lags the voltage (negative means it leads)
X_L, X_C
reactances of the inductor and capacitor (Ω)
Physical meaning
The inductor and capacitor voltages point in opposite directions, so they partly cancel. That is why the separate voltages can add up to more than the supply voltage.

4. Resonance

When XL=XC, the reactances cancel, Z = R and the current is largest. This happens at

ω0=1LC,f0=12πLC

Move the frequency and the parts below to see the peak.

rms current in a series LCR circuit on a 10 V supply as the frequency changes. The peak is at f₀, where the current is V/R and in phase with the voltage. Lower R gives a taller, sharper peak.

Sharpness. The quality factor Q=ω0LR=1RLC. The half-power frequencies (current = I_max/√2) are ω₀ ± R/2L, so the bandwidth is Δω=R/L and Q=ω0/Δω. At resonance the voltage across L (or C) is Q times the supply voltage, which can be dangerously large. A radio tunes to a station by changing C until f₀ matches the station.

Parallel LC resonance is the opposite: the current from the supply is smallest (ideally zero) at f₀.

5. Power and power factor

Average power in an AC circuit:

P=VrmsIrmscos⁡φ=Irms2R

cos φ = R/Z is the power factor. Only the resistor uses energy; L and C store and return it. The part of the current at 90° to the voltage, Irmssin⁡φ, is the wattless current. Factories add capacitors to bring cos φ close to 1, cutting the current (and line losses) for the same useful power. A choke coil (an inductor) limits current in a tube light with almost no power loss, unlike a resistor.

6. LC oscillations

A charged capacitor joined to an inductor swaps energy back and forth between electric (q²/2C) and magnetic (½LI²) forms, like a mass on a spring:

q=Q0cos⁡ωt,ω=1LC,Imax⁡=ωQ0=Q0LC

L plays the part of mass, 1/C of the spring constant, q of displacement and I of velocity. Energy is all magnetic at a quarter period. A resistor in the circuit makes the oscillation die away (damping).

7. Transformers

Two coils on one iron core. For an ideal transformer, VsVp=NsNp=IpIs. Step-up raises voltage and lowers current; power in = power out. Real losses: copper (I²R in windings), eddy currents (reduced by laminated cores), hysteresis (soft iron), and flux leakage. Efficiency η = P_out/P_in.

Why high-voltage transmission? For the same power P, line current is P/V, so the line loss I²R falls as 1/V². Stepping 11 kV up to 220 kV cuts the loss 400 times.

Worked example (level 4). R = 30 Ω, X_L = 80 Ω, X_C = 40 Ω on 200 V rms. Z = √(900 + 1600) = 50 Ω. I = 4 A. cos φ = 30/50 = 0.6, current lags by 53°. Power = 200 × 4 × 0.6 = 480 W = I²R = 16 × 30 ✓. Voltmeters read V_R = 120 V, V_L = 320 V, V_C = 160 V: V_L alone is more than the supply.

  • V_rms = V₀/√2; half-cycle average 2V₀/π; full-cycle average zero.
  • X_L = ωL (current lags 90°); X_C = 1/ωC (current leads 90°).
  • Z = √(R² + (X_L − X_C)²), tan φ = (X_L − X_C)/R; add voltages as phasors, not numbers.
  • Resonance f₀ = 1/2π√(LC): Z = R, φ = 0, current largest; Q = ω₀L/R, bandwidth R/L.
  • P = V_rms I_rms cos φ = I²R; ideal L or C use no power; wattless current I sin φ.
  • LC: ω = 1/√(LC), I_max = Q₀/√(LC); L ↔ mass, 1/C ↔ spring constant.
  • Transformer V_s/V_p = N_s/N_p = I_p/I_s; line loss ∝ 1/V².

Check yourself

1In a series LCR circuit at resonance, the current is:
2An ideal inductor on an AC supply consumes an average power of:
3The rms value of the mains in India is 230 V. Its peak value is about:

Sources

  • National Medical Commission NEET (UG) syllabus and JEE Main / JEE Advanced 2026 syllabi: Alternating currents
  • Indian mains supply 230 V, 50 Hz: Bureau of Indian Standards IS 12360 (voltage bands) https://www.bis.gov.in

Your ticks stay in this browser. Save them as a file on the course home.

Updated 2026-11-22. Syllabus and exam patterns follow the official notices checked on 2026-11-22; they can change every year, so check the official exam website. All questions are original fibub work, not copied from past papers or books. Nothing you do here is sent anywhere.