All lessons

Module 23: Alternating current · Lesson 23.2 · about 26 min

Alternating current: question types and traps

Every way entrance exams ask about AC: rms and average values of different waves, reactance and phase, series LCR with voltmeter readings, resonance, Q factor and bandwidth, power factor and its correction, lamps with chokes, LC oscillations and transformers with transmission losses, each with a method and its trap.

Key points, meanings and formulas on one page: choose "Save as PDF" in the print box.

Physics · Class 12 · about 26 minutes. Read the lesson Alternating current first. Here you meet every question type, with the method and the trap, then practise.

Draw the phasor triangle before you calculate. Resistance along the bottom, net reactance up the side, impedance along the slope: the voltages, the phase angle and the power factor are all read off that one triangle.

The nine question types

1. rms, peak and average. Sine: V₀/√2; square: V₀; triangle: V₀/√3; half-wave: V₀/2. For mixed signals, rms = √(mean of v²). Trap: rms of DC + AC is √(V_dc² + V_ac,rms²), not their sum.
2. Reactance and frequency. X_L ∝ f, X_C ∝ 1/f; DC: inductor a wire, capacitor a gap. Trap: a capacitor on DC carries no steady current at all.
3. Phase and instantaneous values. Read φ from i = I₀ sin(ωt − φ); lead or lag. Plug t into the equations for instantaneous values. Trap: radians versus degrees in ωt.
4. Series circuit with meters. V = √(V_R² + (V_L − V_C)²); readings are rms. Trap: adding readings.
5. Resonance. f₀ = 1/2π√(LC); I = V/R; V_L = V_C = QV. Changing C or L to reach resonance. Trap: R changes the height of the peak, not its position.
6. Q factor and bandwidth. Q = ω₀L/R = ω₀/Δω; half-power points ω₀ ± R/2L. Trap: the bandwidth R/L does not depend on C.
7. Power and power factor. P = V I cos φ = I²R; wattless current I sin φ; adding C to correct cos φ: X_C chosen to cancel X_L. Trap: apparent power VI is in volt-amperes, not watts.
8. Lamp on mains with L, C or R. Find the needed impedance from the lamp's current; the extra element supplies the rest at right angles: X = √(Z² − R²). Trap: subtracting voltages directly for an inductor or capacitor.
9. LC circuits and transformers. Energy swap, q-I relation I = ω√(Q₀² − q²); transformer ratios, efficiency, line losses. Trap: transformers do not work on steady DC.

Worked examples

Example 1 (level 3, rms of a mixed wave). A current is i = 3 + 4 sin ωt (A). Find its rms value.

Solution. The mean of i² = 9 + 16 × ½ + (cross term averages to zero) = 17. I_rms = √17 ≈ 4.12 A. Trap: 3 + 4/√2 = 5.83 A is wrong.

Example 2 (level 4, lamp with a choke). A 100 V, 50 W lamp must run from 200 V, 50 Hz mains, using a pure inductor in series. Find L.

Solution. Lamp current = 50/100 = 0.5 A; lamp resistance = 200 Ω. Total impedance needed = 200/0.5 = 400 Ω. XL=4002−2002=346 Ω. L = 346/(2π × 50) ≈ 1.1 H. The inductor drops √(200² − 100²) ≈ 173 V, not 100 V, because its voltage is at 90° to the lamp’s.

Example 3 (level 4, power factor correction). A motor draws 10 A at 230 V, 50 Hz, with power factor 0.8 (lagging). What capacitor in parallel makes the power factor 1?

Solution. Useful current = 10 × 0.8 = 8 A; wattless (lagging) current = 10 × 0.6 = 6 A. The capacitor must draw 6 A leading: XC=230/6=38.3 Ω, C = 1/(2π × 50 × 38.3) ≈ 83 µF. The line current drops from 10 A to 8 A.

Example 4 (level 5, LC current at a given charge). An LC circuit with L = 10 mH, C = 1 µF starts with Q₀ = 20 µC. Find the current when q = 12 µC.

Solution. ω = 1/√(10⁻² × 10⁻⁶) = 10⁴ rad/s. Energy conservation: I=ωQ02−q2=104400−144×10−6 = 10⁴ × 16 × 10⁻⁶ = 0.16 A. Same form as v = ω√(A² − x²) in SHM.

“At resonance the inductor and capacitor have no voltage across them.” Their voltages are large (Q times the supply) but equal and opposite, so they cancel in the sum. A meter across either one alone shows that big voltage.

Impedance triangle
base R, height X_L − X_C, slope Z; cos φ = R/Z
LC ↔ spring
q ↔ x, I ↔ v, L ↔ m, 1/C ↔ k, ω = 1/√(LC)
Physical meaning
In AC, two voltages can be large and still cancel, because they peak at different moments; only the phasor sum must match the supply.

Practise

The set climbs from level 1 to level 5 and includes numericals, assertion-reason, statements, matching lists, multi-correct and passage questions. Templates give new numbers each time.

  • Nine types: rms values, reactance, phase, meter readings, resonance, Q and bandwidth, power factor, lamps with L or C, LC and transformers.
  • rms of DC + AC: √(V_dc² + V_rms²).
  • Series element for a lamp: X = √(Z² − R²).
  • Power factor correction: capacitor current equals the lagging wattless current.
  • LC: I = ω√(Q₀² − q²); equal energies at q = Q₀/√2.
  • Bandwidth R/L; Q = ω₀L/R; V_L = V_C = QV at resonance.

Check yourself

1In a series LCR circuit, voltmeters across R, L and C read 30 V, 90 V and 50 V. The supply voltage is:
2The frequency of the supply is doubled. The reactance of a capacitor:
3In an LC circuit the energy is shared equally between the capacitor and the inductor when the charge is:

Sources

  • JEE Main, JEE Advanced 2026 and NEET (UG) syllabi: Alternating currents; question patterns studied from the exams' published papers (no questions copied)

Your ticks stay in this browser. Save them as a file on the course home.

Updated 2026-11-22. Syllabus and exam patterns follow the official notices checked on 2026-11-22; they can change every year, so check the official exam website. All questions are original fibub work, not copied from past papers or books. Nothing you do here is sent anywhere.