Module 16: Waves and sound · Lesson 16.1 · about 38 min
Waves and sound
Transverse and longitudinal waves, the wave equation and its terms, speed on a string and in gases, energy and intensity, decibels, reflection, superposition and interference, standing waves on strings and in open and closed pipes, resonance tubes and end correction, beats and the Doppler effect.
Physics · Class 11 · about 38 minutes. By the end you will be able to read a wave equation, find wave speeds on strings and in gases, handle intensity and decibels, explain interference and standing waves, find the harmonics of strings and pipes, and solve beats and Doppler problems.
1. What a wave is
In a transverse wave the medium moves at right angles to the wave’s travel (a string, ripples, light). In a longitudinal wave it moves along the travel direction, in compressions and rarefactions (sound). Mechanical waves need a medium; sound cannot cross a vacuum.
A sine wave travelling in the +x direction:
- A
- amplitude, the largest displacement of a particle
- λ, k
- wavelength, and wave number 2π/λ (rad/m)
- f, ω
- frequency (Hz) and angular frequency 2πf
- v
- wave speed, set by the medium, not by the source
- Physical meaning
- Each particle does SHM at frequency f. The wave is the pattern of their phases, sliding along at v.
means travel in −x. The particle velocity is not the wave velocity; its maximum is Aω. Also : particle velocity = −(wave speed) × (slope of the string). Phase difference between two points: .
2. Wave speed
- String with tension T and mass per length μ: .
- Sound in a gas: . (Newton used γ = 1 and got 280 m/s; Laplace saw that sound compressions are adiabatic.)
- Liquids and solids: and for a rod.
Sound in air: v ∝ √T (about +0.6 m/s per °C), does not change with pressure at fixed T, and rises with humidity (moist air is lighter).
3. Energy, intensity and loudness
A wave carries power on a string. Intensity I = power per area (W/m²), ∝ A²f². From a point source, , so I ∝ 1/r² and A ∝ 1/r.
Sound level in decibels: , with W/m² (the faintest sound we hear). Ten times the intensity adds 10 dB; doubling adds 3 dB.
4. Reflection and superposition
At a fixed end (or a denser medium) a wave reflects upside down: a phase change of π. At a free end (or a rarer medium) it reflects upright. Transmitted waves never flip.
Superposition: where waves meet, their displacements add. Two waves of the same frequency with phase difference φ give amplitude .
- Constructive: path difference = nλ (phase 2nπ), .
- Destructive: path difference = (n + ½)λ, .
- Intensities: .
5. Standing waves: strings and pipes
Two equal waves travelling opposite ways make a standing wave, . Nodes never move; antinodes swing the most. Neighbouring nodes are λ/2 apart, and a node and the next antinode λ/4. No energy flows along a standing wave.
The ends fix the pattern. Choose a system and a mode below.
| System | Allowed frequencies | Harmonics present |
|---|---|---|
| String fixed at both ends | all: 1, 2, 3, … | |
| Pipe open at both ends | all | |
| Pipe closed at one end | odd only: 1, 3, 5, … |
- Sonometer laws: : f ∝ 1/L, ∝ √T, ∝ 1/√μ.
- End correction: the antinode sits a little beyond the open end, about 0.6r for a tube of radius r. A closed pipe’s effective length is L + 0.6r; an open pipe’s is L + 1.2r.
- Resonance tube: successive resonance lengths differ by λ/2, so , and the end correction cancels out.
“In a pipe, the air is still at the open end.” The open end is a displacement antinode: the air moves most there, and the pressure stays near atmospheric (a pressure node). The closed end is the opposite: air cannot move (displacement node), and pressure swings most.
6. Beats
Two sounds of nearly equal frequencies f₁ and f₂ drift in and out of step. The loudness rises and falls times per second. To find an unknown frequency: load a tuning fork with wax (its frequency falls) or file it (it rises) and see whether the beat rate goes up or down.
7. The Doppler effect
When source and listener move along the line joining them, in still air:
with v_o positive when the listener moves towards the source, and v_s positive when the source moves towards the listener. Approaching raises the pitch; going away lowers it.
- Wind at speed w blowing from source to listener: replace v by v + w.
- Echo from a wall when a car drives at u towards it: .
- If the motion is at an angle, use only the velocity components along the line joining source and listener.
- When , the waves pile up into a shock wave (a sonic boom), in a cone of half-angle .
“The pitch of an approaching train keeps rising as it gets closer.” At constant speed, the pitch heard is steady and high while it approaches, then drops suddenly as it passes, and stays steady and low as it goes away. It is the loudness that keeps rising.
- y = A sin(kx − ωt); v = fλ = ω/k; particle speed is not wave speed; Δφ = (2π/λ)Δx.
- String v = √(T/μ); gas v = √(γRT/M), ∝ √T, independent of pressure.
- I ∝ A²f², point source I ∝ 1/r²; β = 10 log(I/I₀); ×10 intensity = +10 dB.
- Fixed end reflects with phase π; superposition A² = A₁² + A₂² + 2A₁A₂ cos φ.
- Standing waves: nodes λ/2 apart; string and open pipe nv/2L, closed pipe odd harmonics (2n − 1)v/4L.
- Resonance tube v = 2f(L₂ − L₁); end correction 0.6r.
- Beats |f₁ − f₂|; Doppler f’ = f(v + v_o)/(v − v_s).
Check yourself
Sources
- National Medical Commission NEET (UG) syllabus and JEE Main / JEE Advanced 2026 syllabi: Waves
- Speed of sound in dry air ≈ 343 m/s at 20 °C (about 331 m/s at 0 °C); exams often use 330 or 340 m/s
Your ticks stay in this browser. Save them as a file on the course home.
Updated 2026-11-22. Syllabus and exam pattern follow the official NMC and NTA notices checked on 2026-11-22; they can change every year, so check neet.nta.nic.in. All questions are original fibub work, not copied from past papers or books. Nothing you do here is sent anywhere.