Home / Learn / Exam prep / GATE Physics / Lesson 9.1
All lessons

Module 9: Electronics · Lesson 9.1 · about 50 min

Diodes, BJTs, FETs and MOSFETs

Semiconductor devices at GATE depth: the p-n junction (built-in potential, depletion width, junction capacitance, breakdown), the bipolar transistor (regions, Early effect, small-signal gm, rπ and ro), the JFET and the MOSFET (square law, triode and saturation, transconductance, CMOS), and the optoelectronic devices on the syllabus: LEDs, photodiodes and solar cells.

Key points, meanings and formulas on one page: choose "Save as PDF" in the print box.

Module 9 · about 50 minutes. This lesson assumes the JAM basics: semiconductors (carriers, doping, the Fermi level), diodes (rectifiers, Zener regulators) and transistors (configurations and biasing). GATE asks for the physics behind the device equations and for small-signal numbers you can compute in a minute.

Every device here is a junction or a channel whose carrier density is set exponentially or quadratically by a control voltage. The diode and the BJT follow e^{V/V_T}: a 60 mV step multiplies the current by ten. The FET follows a square law in the overdrive V_GS − V_T. Small-signal parameters are just the slopes of these laws at the operating point.

1. The p-n junction

Bring p-type (acceptors Na) and n-type (donors Nd) silicon together. Carriers diffuse across, leave behind fixed ionised dopants, and build up a field that stops further diffusion. In equilibrium the Fermi level is flat, and the potential step is

Vbi=kBTqln⁡NaNdni2,W=2εs(Vbi−V)q(1Na+1Nd),xnxp=NaNd

Depletion approximation. Inside the depletion region all dopants are ionised and there are no free carriers; outside it the material is neutral. Charge density is −qN_a on the p side, +qN_d on the n side.

Charge balance. The total charge is zero, so N_a x_p = N_d x_n: the depletion region reaches further into the lighter-doped side.

Poisson. Integrating once gives a triangular field with peak E_max = qN_d x_n/ε_s at the junction; integrating again gives the potential drop ½E_max W = V_bi − V.

Bias. A forward bias V lowers the barrier and narrows W; a reverse bias (V < 0) widens it. The stored charge changes with V, so the junction is a voltage-dependent capacitor.

`$C_j = \varepsilon_sA/W$`
depletion capacitance; for an abrupt junction `$C_j \propto (V_{bi} - V)^{-1/2}$`, for a linearly graded one `$\propto (V_{bi} - V)^{-1/3}$`. A plot of `$1/C_j^2$` against `$V$` is a straight line whose slope gives the lighter doping and whose intercept gives `$V_{bi}$`. Varactor diodes use this.
`$C_d = \tau I/V_T$`
diffusion capacitance of minority carriers stored under forward bias (`$\tau$` = lifetime); it dominates in forward bias, `$C_j$` in reverse bias
`$I = I_s(e^{V/\eta V_T} - 1)$`
the diode law, with `$V_T = k_BT/q = 25.9$` mV at 300 K and ideality `$\eta$` between 1 (diffusion) and 2 (recombination in the depletion region)
`$r_d = \eta V_T/I$`
small-signal resistance: 26 Ω at 1 mA

Worked example. Silicon at 300 K, Na=1017 cm⁻³, Nd=1016 cm⁻³, ni=1010 cm⁻³, εs=11.7ε0. Then Vbi=0.02586ln⁡(1013)=0.774 V. At zero bias W=0.332 µm, of which xn=0.302 µm lies on the lightly doped n side, and Emax=2Vbi/W=4.7×106 V/m. At 5 V reverse bias W=0.906 µm, so the capacitance falls to 0.37 of its zero-bias value (312 pF per mm² at zero bias).

Temperature and breakdown. Is∝ni2∝T3e−Eg/kBT roughly doubles every 5 K in silicon, so at fixed current the forward voltage falls by about 2 mV/K. Under large reverse bias the junction breaks down: by Zener tunnelling in heavily doped junctions (below about 5 V, negative temperature coefficient, since the gap shrinks when hot) or by avalanche multiplication in lighter ones (above about 7 V, positive coefficient, since phonons shorten the free path). Diodes near 5.6 V have almost no drift.

2. The bipolar transistor

An npn transistor is two junctions sharing a thin, lightly doped base. With the base-emitter junction forward biased and the base-collector junction reverse biased (forward active), electrons injected from the emitter diffuse across the base and are swept into the collector:

IC=ISeVBE/VT(1+VCEVA),IC=βIB,α=ICIE=ββ+1

β is large because the base is thin compared with the diffusion length (few electrons recombine there) and because the emitter is much more heavily doped than the base (few holes are injected back). The Early voltage VA comes from base-width modulation: more collector voltage widens the collector depletion region, thins the neutral base and steepens the electron gradient.

Region B-E junction B-C junction Use
forward active forward reverse amplifier
saturation forward forward closed switch, VCE≈0.2 V
cut-off reverse reverse open switch
reverse active reverse forward rarely used (low β)

The hybrid-π model linearises this at the bias point:

gm=ICVT,rπ=βgm,ro=VAIC,gmro=VAVT

Worked example. IC=1 mA, β=100, VA=50 V, VT=25 mV: gm=40 mS, rπ=2.5 kΩ, ro=50 kΩ. A common-emitter stage with a 5 kΩ collector load has gain −gm(RC∥ro)=−40×4.55=−182. The largest gain any single transistor can give, with an ideal current-source load, is gmro=2000.

3. Field-effect transistors

JFET. A reverse-biased gate junction pinches an n channel. Shockley’s equation in saturation:

ID=IDSS(1−VGSVP)2,gm=2IDSS|VP|(1−VGSVP)=gm0IDIDSS

In self-bias a source resistor sets VGS=−IDRS; substituting gives a quadratic, and only the root with |VGS|<|VP| is physical.

MOSFET. In an n-channel enhancement device a gate voltage above the threshold VT inverts the p surface and forms an electron channel. With kn=μnCoxW/L:

ID={kn[(VGS−VT)VDS−12VDS2]VDS<VGS−VT (triode)12kn(VGS−VT)2(1+λVDS)VDS≥VGS−VT (saturation)
`$V_{ov} = V_{GS} - V_T$`
overdrive; the channel pinches off at the drain end when `$V_{DS}$` reaches it
`$g_m = k_nV_{ov} = 2I_D/V_{ov} = \sqrt{2k_nI_D}$`
transconductance; it grows only as the square root of current, whereas a BJT's grows linearly, so at equal current a BJT has more `$g_m$`
`$r_o = 1/\lambda I_D$`
output resistance from channel-length modulation
`$r_{DS} = 1/k_nV_{ov}$`
resistance near `$V_{DS} = 0$`: a voltage-controlled resistor
body effect
a source above the substrate raises `$V_T$` by `$\gamma(\sqrt{2\phi_F + V_{SB}} - \sqrt{2\phi_F})$`

Worked example. kn=2 mA/V², VT=1 V, VGS=2.5 V: Vov=1.5 V, ID=2.25 mA, gm=3 mS. Saturation needs VDS≥1.5 V. With VDD=10 V the drain resistor must be at most 8.5/2.25=3.8 kΩ. Move the sliders in the figure to see the operating point slide off the flat part of the curve when RD is too large.

MOSFET output curves with the dashed boundary V_DS = V_GS − V_T between triode and saturation, a load line from V_DD through R_D and the operating point; switch to the transfer view to see the square law and the slope g_m at the bias.

A depletion-mode MOSFET has a channel built in, so it conducts at VGS=0 and its VT is negative. CMOS pairs an n-channel and a p-channel device: in either logic state one is off, so the static current is only leakage, and power is spent mainly in charging load capacitance (lesson 9.5).

4. Optoelectronic devices

Device Bias Key relation
LED forward photon energy ≈ Eg, so λ(nm)≈1240/Eg(eV); needs a direct gap (GaAs, GaN), not Si
photodiode reverse responsivity R=ηqλ/hc=ηλ(μm)/1.24 A/W; zero response for λ>hc/Eg
solar cell none (fourth quadrant) I=I0(eV/VT−1)−IL; Voc=VTln⁡(1+IL/I0)

Worked example. A GaAs LED (Eg=1.42 eV) emits near 873 nm. A silicon photodiode with quantum efficiency 0.8 at 850 nm has R=0.8×0.85/1.24=0.55 A/W. A solar cell with IL=35 mA and I0=10−12 A gives Voc=0.02585ln⁡(3.5×1010)=0.63 V. Doubling the light adds only VTln⁡2=18 mV: the open-circuit voltage is logarithmic in intensity, the short-circuit current linear.

Heterojunctions join materials with different gaps (AlGaAs/GaAs). The band offsets confine carriers and light, which makes efficient lasers possible, and they let an emitter inject electrons without receiving holes back, which gives heterojunction bipolar transistors their high β and speed.

“The base current controls the collector current, so a BJT is a current amplifier.” The physics is voltage control: VBE sets the electron injection exponentially, and IB is a by-product (holes injected into the emitter plus recombination in the base). β is a ratio of two currents that both follow eVBE/VT, and it varies by a factor of two between nominally identical transistors, which is why good bias circuits fix VBE and emitter current, not base current.

  • Junction: Vbi=VTln⁡(NaNd/ni2), W∝Vbi−V, depletion mostly on the lightly doped side, Cj∝(Vbi−V)−1/2 (abrupt).
  • Diode: I=Is(eV/ηVT−1), rd=ηVT/I, about −2 mV/K at fixed current; Zener below ~5 V (negative tempco), avalanche above ~7 V (positive).
  • BJT: gm=IC/VT, rπ=β/gm, ro=VA/IC, intrinsic gain VA/VT; active = BE forward, BC reverse.
  • JFET: ID=IDSS(1−VGS/VP)2; self-bias gives a quadratic, keep |VGS|<|VP|.
  • MOSFET: saturation when VDS≥VGS−VT, ID=12knVov2, gm=2ID/Vov.
  • LED λ≈1240/Eg nm; photodiode R=ηλ/1.24 A/W; solar cell Voc=VTln⁡(1+IL/I0).

Practise: exam questions on this lesson

Next: lesson 9.2 builds amplifiers from these small-signal models and shows how feedback trades gain for bandwidth and stability. Try circuits like these in the circuit simulator.

Going on to CSIR NET? Transducers and detectors puts photodiodes and other junction devices to work as sensors.

Check yourself

1Raising the reverse bias on an abrupt p-n junction from 0 to a value that makes V_bi − V eight times larger changes the junction capacitance by a factor of
2A BJT is biased at I_C = 2 mA with V_T = 25 mV, β = 150 and Early voltage 60 V. Its intrinsic voltage gain g_m r_o is
3An n-channel MOSFET in saturation has its overdrive V_GS − V_T doubled at fixed W/L. Its drain current and transconductance change by

Sources

  • S. M. Sze and K. K. Ng, Physics of Semiconductor Devices, 3rd ed. (2007), chapters 2, 5, 6 and 13
  • A. S. Sedra and K. C. Smith, Microelectronic Circuits, 7th ed. (2015), chapters 4 to 7
  • B. G. Streetman and S. K. Banerjee, Solid State Electronic Devices, 7th ed. (2015), chapters 5 to 8
  • GATE Physics (PH) syllabus, Electronics section, published by the organising IIT each year

Your ticks stay in this browser. Save them as a file on the course home.

Updated 2026-11-22. Not affiliated with the IITs, IISc or the GATE organising institute. The general aptitude part of GATE is not covered here. Check the official GATE website for the current pattern. All questions are original.