Home / Learn / Exam prep / CUET (UG) prep / Lesson 6.4
All lessons

Module 6: Physics · Lesson 6.4 · about 22 min

Physics: electromagnetic induction and AC

Faraday's and Lenz's laws, motional emf, self and mutual inductance, AC with resistors, inductors and capacitors, resonance, power factor and the transformer, with a live transformer problem.

Key points, meanings and formulas on one page: choose "Save as PDF" in the print box.

Module 6 · about 22 minutes. By the end you will find induced emfs and directions and solve LCR and transformer questions. Read first: moving charges and magnetism.

A changing magnetic flux makes an emf, and the induced current always fights the change. Every generator, transformer and induction cooktop runs on this one idea.

Everyday picture: drop a magnet down a copper pipe and it falls slowly, as if through honey. The falling magnet changes the flux through rings of the pipe, currents swirl in the copper, and their field pushes back on the magnet.

1. Faraday and Lenz

ε=−NdΦBdtεmotional=Blvε=−LdIdt
Φ_B = BA cos θ
magnetic flux, in weber. Change B, the area, or the angle and you induce an emf.
minus sign
Lenz's law: the induced current makes a field that opposes the change in flux.
L (self-inductance)
a coil's "inertia" for current, in henry. It resists changes in current the way mass resists changes in velocity. Energy stored = ½LI².
Step 1: which way does the field through the loop point, and is the flux growing or shrinking?
Step 2: the induced field points opposite if the flux grows, the same way if it shrinks.
Step 3: curl your right-hand fingers so your thumb points along that induced field. Your fingers give the current.
Check: a magnet's N pole approaching a loop makes the near face of the loop an N pole too, so they repel.

2. Alternating current

Element Reactance Phase of current
Resistor R in step with voltage
Inductor X_L = ωL lags voltage by 90°
Capacitor X_C = 1/(ωC) leads voltage by 90°
Series LCR Z = √(R² + (X_L − X_C)²) resonance at ω₀ = 1/√(LC)

Average power P = V_rms I_rms cos φ, where cos φ = R/Z is the power factor. A pure inductor or capacitor draws current but uses no average power (“wattless current”).

3. Transformer

An ideal transformer keeps power the same: V_s/V_p = N_s/N_p = I_p/I_s. Power lines step voltage up to cut the current, and so the I²R loss, then step it down near homes. Real transformers lose a little energy to eddy currents (cut by laminating the core), hysteresis and resistance.

“A step-up transformer gives you more energy.” It raises the voltage but lowers the current by the same factor. Power in = power out at best.

4. Practice

  • ε = −N dΦ/dt; motional emf Blv; Lenz = energy conservation.
  • Self-inductance: ε = −L dI/dt, energy ½LI².
  • X_L = ωL (current lags), X_C = 1/ωC (current leads); resonance at ω₀ = 1/√(LC).
  • V_rms = V₀/√2; P = V_rms I_rms cos φ.
  • Transformer: V_s/V_p = N_s/N_p, power stays the same.

Check yourself

1Lenz's law is a consequence of conservation of:
2At resonance in a series LCR circuit:
3The rms value of an AC voltage with peak 311 V is about:

Sources

  • NCERT, Physics Part I (Class 12), Electromagnetic Induction; Alternating Current
  • National Testing Agency, CUET (UG) Physics syllabus https://cuet.nta.nic.in/ (checked 2026-11-22)
  • Questions: original fibub writing for this course

Your ticks stay in this browser. Save them as a file on the course home.

Updated 2026-11-22. The exam pattern follows the NTA CUET (UG) information bulletin as checked on 2026-11-22: check cuet.nta.nic.in for the current year. fibub is a free independent site, not part of NTA; every question here is original. Practice runs in your browser and nothing you answer is sent anywhere.