Home / Learn / Exam prep / SAT prep / Lesson 4.2
All lessons

Module 4: Problem-solving and data analysis · Lesson 4.2 · about 15 min

Units, unit rates and density

Convert units by multiplying by fractions equal to 1, handle square and cubic units, and use rates and density the way the SAT tests them.

Key points, meanings and formulas on one page: choose "Save as PDF" in the print box.

Module 4 · about 15 minutes · read first: 4.1 Ratios, rates and percent. By the end you will convert any unit without memorising which way to multiply.

A conversion factor is a fraction equal to 1, like 12 inches over 1 foot. Multiplying by 1 never changes an amount, only its units. Line the fractions up so the unwanted units cancel.

1. Cancel units like numbers

Change 45 miles per hour into feet per second. Write it as a fraction: 45 miles / 1 hour.
Miles must cancel, so put miles on the bottom: × 5,280 feet / 1 mile.
Hours must cancel, so put hours on top: × 1 hour / 3,600 seconds.
45 × 5,280 ÷ 3,600 = 66 feet per second. Check the size: there are far more feet than miles and far more seconds than hours, and the answer is sensible for a car.
Conversion factor
a fraction whose top and bottom are the same amount in different units (60 minutes / 1 hour)
Square and cubic units
an area has two lengths in it, a volume three, so the length factor is used twice or three times: 1 m² = 100 × 100 cm²
Physical meaning
Density (mass per volume) tells you whether a thing floats in water (less than 1 g/cm³) and is the same for a pebble or a mountain of the same rock.

2. Area and volume units

A floor of 4 m by 3 m is 12 m². In centimetres it is 400 by 300 = 120,000 cm². So 1 m² is 10,000 cm², not 100. For volume, 1 m³ = 100³ = 1,000,000 cm³.

3. Rates and density

Rate questions chain several steps: miles to gallons to dollars, or pages to minutes. Density is mass ÷ volume, and the SAT often gives a shape whose volume you must work out first.

“To go from a big unit to a small one, always multiply.” That works for single units, but rates flip it: going from per hour to per second makes the number smaller. Let the units cancel and you never need the rule.

Practice set

Ten questions on this lesson, from warm-up to hard, in the SAT’s own formats (four options or a typed answer). Press New numbers for a fresh set; every question has a full worked solution.

  • Multiply by fractions equal to 1 and cancel units like numbers.
  • Square units use the factor twice; cubic units three times.
  • Density = mass ÷ volume; work out the volume first.
  • Check the answer’s size makes sense.

Check yourself

1How many square inches are in 3 square feet? (1 ft = 12 in)
2A block has mass 60 g and volume 20 cm³. Its density is:
3To change 72 km per hour into metres per second, you:

Sources

Your ticks stay in this browser. Save them as a file on the course home.

Updated 2026-11-22. SAT is a trademark of the College Board, which is not involved with and does not endorse fibub. Every question here is original. Test details were checked on the College Board's website on 22 November 2026; check the official source before test day.