Electric potential and capacitors
Class 12 · 182 questions and templates for Medical entrance (NEET), in order from warm-up to top rank. Check each answer, then read the full solution.
New to this topic? Read the lesson first: Electric potential and capacitors.
Loading questions… (they need JavaScript; nothing you type is sent anywhere)
Written questions with solutions
The same questions as a list, so you can print them or read without the practice box. Templates (fresh numbers) appear only in the practice box above.
-
MCQWarm-up
The SI unit of electric potential, the volt, is the same asAnswer and solution
Answer: B
Potential is work per unit charge, , so 1 V = 1 J/C. N/C is the unit of electric field (it equals V/m). -
MCQWarm-up
The electric potential at a distance from a negative point charge (zero at infinity) is- negative, equal to
- positive, equal to
- zero, because the charge is negative
- negative, equal to
Answer and solution
Answer: A
Potential is a scalar and carries the sign of the source charge: . It falls as , not (that is the field). -
NATWarm-up
Find the potential at 0.3 m from a point charge of nC (in volts). SI.Answer and solution
Answer: 90 V (±0.5)
V. -
MCQWarm-up
Inside a charged conductor in electrostatic equilibrium the potential is- zero
- highest at the centre
- decreasing steadily from the surface to the centre
- the same everywhere and equal to its surface value
Answer and solution
Answer: D
The field inside is zero, so does not change from point to point: the whole conductor is an equipotential. It is not zero in general (a charged sphere at 900 V has 900 V inside too).Why people get this wrong: Zero field does not mean zero potential.
-
MCQWarm-up
The electric field at any point of an equipotential surface is- parallel to the surface
- zero everywhere on it
- perpendicular to the surface
- at to the surface
Answer and solution
Answer: C
If the field had a component along the surface, a charge would gain energy when moved along it, so the potential would change. Hence the field is normal to the surface. (It need not be zero: the surface of a point charge's equipotential has non-zero field.) -
MCQWarm-up
The capacitance of a parallel plate capacitor does NOT depend on- the area of the plates
- the charge on the plates
- the gap between the plates
- the medium between the plates
Answer and solution
Answer: B
depends only on geometry and the medium. changes with the voltage, but stays the same. -
NATWarm-up
A F capacitor is connected to a 12 V battery. How much charge does it store (in C)?Answer and solution
Answer: 24 µC (±0.1)
C. -
MCQWarm-up
The gap between the plates of an isolated parallel plate capacitor is doubled (same plates and medium). Its capacitance becomes- half
- double
- one-fourth
- unchanged
Answer and solution
Answer: A
, so . Doubling halves . -
MCQWarm-up
Capacitors and are joined in series. The equivalent capacitance is- equal to
- larger than the larger of the two
- always the average of the two
- smaller than the smaller of the two
Answer and solution
Answer: D
, so is bigger than either or and is smaller than both. Parallel is the one that adds. -
NATWarm-up
Capacitors of F, F and F are connected in parallel. Find the equivalent capacitance (in F).Answer and solution
Answer: 15 µF
In parallel the capacitances add: F. -
NATWarm-up
A F capacitor is charged to 20 V. Find the energy stored (in mJ).Answer and solution
Answer: 2 mJ (±0.01)
J mJ. -
MCQWarm-up
When a dielectric of constant completely fills the space between the plates of a capacitor, the capacitance becomes- of the original
- times the original
- times the original
- unchanged
Answer and solution
Answer: C
Polarised molecules of the dielectric reduce the field inside, so the same charge needs a smaller voltage: , with . -
MCQWarm-up
The work done in moving a charge between two points on the same equipotential surface is- positive
- zero
- negative
- dependent on the path
Answer and solution
Answer: B
and , so along any path between the two points. -
MCQWarm-up
One electron volt (eV) is equal to- J
- J
- J
- V
Answer and solution
Answer: A
It is the energy gained by one electron ( C) in falling through 1 volt: J. It is a unit of energy, not of potential. -
MCQWarm-up
The electric potential at any point on the perpendicular bisector (equatorial line) of an electric dipole is- maximum
- proportional to
- negative
- zero
Answer and solution
Answer: D
Every point on the bisector is equally far from and , so the two potentials cancel. The field there is not zero.Why people get this wrong: The potential vanishes on the bisector, but the field does not.
-
MCQWarm-up
The relation between the electric field and the potential along isAnswer and solution
Answer: C
The field points in the direction of fastest fall of potential, so . Its unit is V/m, the same as N/C. -
NATWarm-up
An alpha particle (charge ) is accelerated from rest through a potential difference of 500 V. Find its kinetic energy gained (in eV).Answer and solution
Answer: 1000 eV
Energy eV. Using eV directly avoids the factor. -
NATStandard
Charges C and C are 0.6 m apart in air. Find the potential at the midpoint of the line joining them (in kV). SI.Answer and solution
Answer: -60 kV (±0.5)
Each charge is 0.3 m from the midpoint. Add the potentials as scalars, with signs: V kV.Why people get this wrong: Potentials add as numbers, with signs; fields add as vectors.
-
NATStandard
Four equal charges of 5 nC sit at the corners of a square of side 0.2 m. Find the potential at the centre of the square (in V). SI.Answer and solution
Answer: 1273 V (±2)
Each corner is at m from the centre. V. (The field at the centre is zero, the potential is not.) -
NATStandard
A charge of C is moved from a point A at 80 V to a point B at V. Find the work done BY the electric field (in J).Answer and solution
Answer: 200 µJ (±0.5)
J. The charge goes from high to low potential, so a positive charge is helped by the field. -
NATStandard
An electron starts from rest and is accelerated through 200 V. Find its final speed (in units of , 2 decimals; C, kg).Answer and solution
Answer: 8.39 ×10⁶ m/s (±0.02)
, so . -
NATStandard
Point charges of C and C are 0.9 m apart. Find the electric potential energy of the pair (in J). SI.Answer and solution
Answer: 0.15 J (±0.002)
J. -
NATStandard
Three identical charges of C are placed at the corners of an equilateral triangle of side 0.3 m. Find the electric potential energy of the system (in J).Answer and solution
Answer: 0.36 J (±0.002)
There are 3 pairs, each at 0.3 m: J. -
NATStandard
A thin ring of radius 0.3 m carries a uniform charge of C. Find the potential at a point on its axis 0.4 m from the centre (in kV).Answer and solution
Answer: 144 kV (±0.5)
Every bit of charge is at the same distance m, so V kV. -
NATStandard
A thin conducting shell of radius 0.2 m carries C. Find the potential at a point 0.1 m from its centre (in kV).Answer and solution
Answer: 180 kV (±0.5)
Inside a shell the potential is constant and equals its surface value: V kV. Using m would give 360 kV: wrong.Why people get this wrong: Inside, V is constant, not kQ/r.
-
NATStandard
A parallel plate capacitor has plates of area separated by 2 mm of air. Find its capacitance (in pF). Take and .Answer and solution
Answer: 88.5 pF (±0.2)
F pF. (Change to : .)Why people get this wrong: Convert cm² to m² and mm to m.
-
NATStandard
A F and a F capacitor are connected in series across a 12 V battery. Find the potential difference across the F capacitor (in V).Answer and solution
Answer: 8 V (±0.1)
F, so C on each. V (and V). The smaller capacitor takes the larger share of the voltage. -
NATStandard
Find the capacitance of an isolated conducting sphere of radius 0.9 m (in pF). SI.Answer and solution
Answer: 100 pF (±0.5)
F pF. -
NATStandard
The electric field in a region of air is . Find the energy stored per unit volume (in , 2 decimals; ).Answer and solution
Answer: 0.4 J/m³ (±0.01)
. -
NATStandard
A dipole has charges nC separated by 1 cm. Find the potential at a point on its axis 10 cm from its centre, on the side of the positive charge (in V; use the small-dipole formula, SI).Answer and solution
Answer: 18 V (±0.5)
C m. On the axis V.