Oscillators
Electronics · 82 questions and templates for GATE Physics, in order from warm-up to top rank. Check each answer, then read the full solution.
New to this topic? Read the lesson first: Oscillators.
Loading questions… (they need JavaScript; nothing you type is sent anywhere)
Written questions with solutions
The same questions as a list, so you can print them or read without the practice box. Templates (fresh numbers) appear only in the practice box above.
-
MCQWarm-up
An amplifier of gain with a feedback network sustains a steady sinusoidal oscillation at the frequency where- with
- and the phase of is (or a multiple of )
Answer and solution
Answer: C
For a signal to keep itself going around the loop it must come back exactly as it left: same amplitude () and same phase (total phase shift or ). This is the Barkhausen criterion; the frequency is fixed by the phase condition.Why people get this wrong: is the condition for a feedback amplifier written with a minus sign at the mixer (); be clear which convention a question uses.
-
MCQWarm-up
A sinusoidal oscillator is best described as- an amplifier with positive feedback at one frequency, with loop gain one there
- an amplifier with strong negative feedback at all frequencies
- a filter with no amplifier
- a rectifier followed by a capacitor
Answer and solution
Answer: A
The feedback network selects one frequency at which the fed-back signal is in phase with the input (positive, regenerative feedback) and the amplifier makes up the network's loss. Everywhere else the loop gain is below one or the phase is wrong, so only that frequency survives.Why people get this wrong: Negative feedback stabilises amplifiers; oscillators need the fed-back signal to add to the input.
-
MCQWarm-up
A Wien bridge oscillator uses equal resistors and equal capacitors in its lead-lag network. It oscillates at- hertz
Answer and solution
Answer: D
The series and parallel arms give a transfer function with zero phase at , where it equals 1/3. So , and the amplifier must have a gain of 3.Why people get this wrong: belongs to the RC phase-shift oscillator.
-
NATWarm-up
A Colpitts oscillator has H and two tank capacitors of nF each. It oscillates at about ______ MHz (to two decimal places).Answer and solution
Answer: 1.59 MHz (±0.01)
The two capacitors are in series around the tank: nF. MHz.Why people get this wrong: Adding the capacitors (4 nF) as if in parallel gives 0.80 MHz.
-
MCQWarm-up
Quartz crystals are used to fix the frequency of clocks and radio transmitters mainly because- they amplify the signal
- their resonance has an extremely high quality factor, so the frequency hardly drifts
- they have no capacitance
- they work only at audio frequencies
Answer and solution
Answer: B
A crystal is a piezoelectric mechanical resonator with of to . The phase of its impedance changes extremely steeply near resonance, so changes elsewhere in the circuit shift the frequency by only parts per million.Why people get this wrong: The crystal is passive: the transistor or op-amp supplies the gain.
-
MSQWarm-up
Which of these are RC oscillators (frequency set by resistors and capacitors, no inductor)?- Wien bridge oscillator
- RC phase-shift oscillator
- Colpitts oscillator
- Twin-T oscillator
Answer and solution
Answer: A, B, D
Wien bridge, phase-shift and twin-T oscillators use networks and are common at audio frequencies, where inductors would be bulky. The Colpitts oscillator uses an tank (a tapped capacitor across an inductor).Why people get this wrong: The Colpitts circuit has two capacitors, but its frequency needs the inductor.
-
MCQWarm-up
The tank capacitance of an LC oscillator is made four times larger, with the inductance unchanged. The oscillation frequency- doubles
- halves
- falls to a quarter
- falls by a factor of
Answer and solution
Answer: B
, so . Four times the capacitance gives of the frequency.Why people get this wrong: Treating as inversely proportional to (a quarter) forgets the square root.
-
NATStandard
A Wien bridge oscillator uses a non-inverting op-amp amplifier with k from the inverting input to ground. The feedback resistor needed for a loop gain of exactly one is ______ k.Answer and solution
Answer: 20 kΩ
At the lead-lag network passes with zero phase, so the amplifier gain must be : k. In practice it is set slightly higher to start, with a non-linear element to settle.Why people get this wrong: Setting gives a gain of 4: the output grows until it clips.
-
MCQStandard
An RC phase-shift oscillator uses three identical high-pass sections in a ladder driven by an inverting amplifier. The minimum magnitude of amplifier gain is- 3
- 29
- 8
- 1/29
Answer and solution
Answer: B
Solving the ladder gives with . The phase is when , and then . The inverting amplifier supplies the other and a gain of at least 29.Why people get this wrong: 8 is the gain for three buffered (isolated) sections of each; the loaded ladder needs 29.
-
NATStandard
An RC phase-shift oscillator with three identical high-pass sections uses k and nF. Its frequency is ______ Hz (to the nearest whole number).Answer and solution
Answer: 650 Hz (±2)
Hz.Why people get this wrong: Using Hz (the Wien frequency).
-
NATStandard
A Hartley oscillator has a tapped coil with sections of mH and mH (no mutual coupling between them) and a nF tank capacitor. Its frequency is ______ kHz (to one decimal place).Answer and solution
Answer: 100.7 kHz (±0.3)
With no coupling, mH. kHz.Why people get this wrong: Combining the coil sections in parallel.
-
MCQStandard
In a Colpitts oscillator, the fraction of the tank voltage fed back to the amplifier input is set mainly by- the value of the inductor
- the supply voltage
- the ratio of the two tank capacitors
- the load resistance alone
Answer and solution
Answer: C
The two capacitors form a capacitive voltage divider across the tank; the tap between them feeds the amplifier. Changing their ratio changes the feedback fraction (and the gain needed), while their series value with sets the frequency.Why people get this wrong: The inductor sets the frequency, not the feedback fraction.
-
MCQStandard
Practical oscillators are designed with- loop gain exactly 1 from the moment they are switched on
- loop gain well below 1, so the oscillation is stable
- loop gain slightly above 1 at start-up, with a non-linearity that brings it down to exactly 1 at the final amplitude
- no feedback at all
Answer and solution
Answer: C
Oscillation starts from noise, so the small-signal loop gain must exceed 1 for the amplitude to grow. As it grows, a non-linear element (amplifier saturation, a lamp, thermistor, diodes or an AGC loop) reduces the gain until the average loop gain is exactly 1. A lamp or thermistor gives a cleaner sine than clipping.Why people get this wrong: Exactly 1 at switch-on: any small loss and the oscillation would never start.
-
MCQStandard
A quartz crystal's motional arm has H and pF. Its series resonant frequency is about- 159 kHz
- 15.9 MHz
- 1.59 MHz
- 5.0 MHz
Answer and solution
Answer: C
MHz. The huge and tiny model the mechanical mass and stiffness of the quartz plate.Why people get this wrong: Slipping a power of ten under the square root.
-
MSQStandard
About a Wien bridge oscillator with equal and equal , which statements are correct?- At the lead-lag network has zero phase shift
- At the lead-lag network passes one third of its input
- The amplifier must be inverting
- An NTC thermistor in place of can stabilise the amplitude
Answer and solution
Answer: A, B, D
The network transfer is : real and equal to at . Zero phase means the amplifier must be non-inverting with gain 3. If the amplitude grows, the thermistor warms, its resistance falls, the gain falls: automatic level control.Why people get this wrong: Inverting amplifiers go with the phase-shift oscillator, whose network gives .
-
NATStandard
A UJT relaxation oscillator has k, F and intrinsic stand-off ratio (diode drop and discharge time neglected). Its frequency is ______ Hz (to the nearest whole number).Answer and solution
Answer: 1091 Hz (±3)
The capacitor charges from about 0 towards and the UJT fires at : , so ms and Hz.Why people get this wrong: Using instead of .
-
MCQStandard
At the frequency where its loop phase is zero, an oscillator circuit has loop gain . After it is disturbed, the oscillation- grows until the amplifier clips
- dies away gradually
- continues at constant amplitude
- jumps to twice the frequency
Answer and solution
Answer: B
Each trip around the loop multiplies the amplitude by 0.98, so the oscillation decays (slowly, like a lightly damped resonator). Sustained oscillation needs at least 1.Why people get this wrong: Close to 1 is not 1: the amplitude still decays exponentially.
-
MCQStandard
Which pairing of oscillator and its feedback tap is correct?- Colpitts: tapped inductor; Hartley: tapped capacitor
- Hartley: tapped inductor; Colpitts: tapped capacitor
- Both use a tapped capacitor
- Both use an RC ladder
Answer and solution
Answer: B
Hartley taps the coil (two inductors in series across one capacitor); Colpitts taps the capacitance (two capacitors in series across one inductor). The Clapp is a Colpitts with an extra capacitor in series with the inductor.Why people get this wrong: A memory aid: Colpitts and capacitor both start with C.
-
MCQStandard
A frequency synthesiser locks a voltage-controlled oscillator to a MHz crystal reference. The VCO output passes through a divide-by- counter before the phase detector compares it with the reference. In lock, the VCO runs at- kHz
- MHz
- MHz
- GHz
Answer and solution
Answer: D
In lock the two inputs of the phase detector have the same frequency: MHz, so GHz. Changing the division ratio steps the output in MHz steps, each as stable as the crystal.Why people get this wrong: kHz is the reference divided by 125; the divider is in the feedback path, so it multiplies.
-
NATStandard
A two-transistor astable multivibrator has timing components k, nF for one half-cycle and k, nF for the other. Each half-cycle lasts . Its frequency is ______ kHz (to two decimal places).Answer and solution
Answer: 3.61 (±0.02)
Half-periods: s and s. Period s, so kHz. The output is high for 25% or 75% of the cycle depending on which collector is used.Why people get this wrong: Using only one time constant, or without the .
-
MCQStandard
A two-transistor monostable multivibrator has timing resistor k and timing capacitor nF; its pulse lasts . When triggered it gives an output pulse of about- ms
- ms
- ms
- ms
Answer and solution
Answer: C
ms, and the pulse is ms. The circuit then returns to its one stable state and waits for the next trigger.Why people get this wrong: Quoting itself ( ms) leaves out the from the capacitor recharging through half its swing.
-
NATExam level
A Wien network has a series arm k, nF and a parallel arm k, nF. The non-inverting amplifier gain needed for oscillation is ______ (to two decimal places).Answer and solution
Answer: 2.5 (±0.01)
. The imaginary part vanishes at (1125 Hz here), where . So the gain must be 2.5.Why people get this wrong: Assuming the gain is always 3; that needs equal and equal .
-
MCQExam level
In the three-section RC ladder of a phase-shift oscillator at its oscillation frequency, which statement is correct?- Each section gives exactly
- The total shift is , but the sections load each other and their individual shifts are unequal
- The total shift is
- The ladder gives no attenuation
Answer and solution
Answer: B
Only the total matters: , at for high-pass sections. Because each section loads the one before, the shifts are not apiece; that is why the attenuation is 29 rather than the 8 of buffered sections.Why people get this wrong: The equal- picture is true only with buffers between sections.
-
NATExam level
A Colpitts oscillator has H, nF and nF. Its frequency is ______ kHz (to the nearest whole number).Answer and solution
Answer: 528 kHz (±2)
nF, dominated by the smaller capacitor. kHz.Why people get this wrong: Using only gives 159 kHz.
-
NATExam level
A 10 MHz crystal (series resonance) has motional capacitance pF and shunt capacitance pF. Its parallel resonance lies above the series resonance by ______ kHz (to two decimal places).Answer and solution
Answer: 19.98 kHz (±0.05)
At parallel resonance the motional arm resonates with in series with : . kHz, about kHz: the two resonances are very close.Why people get this wrong: Using instead of .
-
MCQExam level
A crystal's motional arm has H and series resistance , resonating at MHz. Its quality factor is aboutAnswer and solution
Answer: A
. An tank of discrete parts rarely exceeds a few hundred.Why people get this wrong: Forgetting the gives .
-
MSQExam level
Which statements about the Barkhausen criterion are correct?- At the oscillation frequency and (mod )
- Meeting it guarantees a stable, constant amplitude without any non-linearity
- If at the zero-phase frequency, the amplitude grows until a non-linearity limits it
- The oscillation frequency is fixed by the phase condition
Answer and solution
Answer: A, C, D
Barkhausen describes the steady state. A linear loop with exactly is marginal: the slightest change makes the amplitude grow or decay, so real oscillators rely on an amplitude-dependent gain. The phase condition picks the frequency; the magnitude condition fixes the amplitude through the non-linearity.Why people get this wrong: Barkhausen is necessary for steady oscillation, not a recipe for amplitude stability.
-
NATExam level
A phase-shift oscillator uses three identical low-pass (series , shunt ) sections in a ladder, with k and nF. It oscillates at ______ Hz (to the nearest whole number).Answer and solution
Answer: 3898 Hz (±10)
For the low-pass ladder with . The phase is at : Hz, and again .Why people get this wrong: Using the high-pass result ; the roles of and swap.
-
MCQExam level
A Hartley oscillator's tapped coil has sections mH and mH with coupling coefficient , wound so that their fluxes aid. The effective tank inductance is- 5 mH
- 7 mH
- 3 mH
- 6 mH
Answer and solution
Answer: B
mH. Series-aiding coils: mH.Why people get this wrong: Adding once, or subtracting it (3 mH is series-opposing).
-
MCQExam level
Both capacitors of an equal-component Wien bridge oscillator drift up by 2%. Its frequency- rises by about 2%
- falls by about 4%
- is unchanged
- falls by about 2%
Answer and solution
Answer: D
, so : , a fall of 1.96%. The required gain stays 3 because the network stays balanced.Why people get this wrong: Thinking of as in an tank (that would give 1%).