Home / Courses / IIT JAM Physics / Practice / Superconductivity

Superconductivity

Solid state physics and devices · 9 questions and templates for IIT JAM Physics, in order from warm-up to top rank. Check each answer, then read the full solution.

Loading questions… (they need JavaScript; nothing you type is sent anywhere)

Written questions with solutions

The same questions as a list, so you can print them or read without the practice box. Templates (fresh numbers) appear only in the practice box above.

  1. MCQWarm-up

    A sample is cooled through its superconducting transition while sitting in a weak magnetic field. The Meissner effect means that
    1. the field inside stays frozen at the value it had before cooling
    2. the field is expelled from the interior, so B=0 inside
    3. the field inside doubles
    4. the resistance becomes zero but nothing happens to the field
    Answer and solution

    Answer: B

    A merely perfect conductor (ρ=0) obeys d𝐁/dt=0 inside, so it would trap the field present when it became perfect. A superconductor actively expels the field (except within the penetration depth λ): B=0 inside whatever the history. So superconductivity is a thermodynamic phase, not just zero resistance.
  2. MCQWarm-up

    The magnetic flux through a thick superconducting ring is quantised in units of
    1. h/e=4.14×10−15 Wb
    2. h/4e=1.03×10−15 Wb
    3. h/2e=2.07×10−15 Wb
    4. e/h=2.42×1014 Wb−1
    Answer and solution

    Answer: C

    The pair wavefunction must be single-valued around the ring, and the carriers have charge 2e, so Φ=nh/2e. Φ0=6.626×10−34/(2×1.602×10−19)=2.07×10−15 Wb. Its measurement in 1961 showed the carriers are pairs.

    Why people get this wrong: h/e would be the flux quantum for single-electron carriers.

  3. NATWarm-up

    A type-I superconductor has Tc=7.2 K and critical field Bc(0)=0.080 T, with Bc(T)=Bc(0)[1−(T/Tc)2]. At 3.6 K the critical field is ______ T (to three decimal places).
    Answer and solution

    Answer: 0.06 (±0.001)

    T/Tc=0.5, so Bc=0.080(1−0.25)=0.060 T.

    Why people get this wrong: Using 1−T/Tc (linear) gives 0.040 T.

  4. MSQWarm-up

    Which statements about type-I and type-II superconductors are correct?
    1. Type-II superconductors are useless for magnets because their critical fields are smaller.
    2. A type-I superconductor shows a complete Meissner effect up to Hc, then becomes normal.
    3. A type-II superconductor lets flux in as quantised vortices between Hc1 and Hc2.
    4. Most elemental superconductors such as Pb, Sn and Al are type I.
    Answer and solution

    Answer: B, C, D

    Type I: full expulsion up to Hc (tens of mT). Type II: full expulsion below Hc1, a mixed (vortex) state up to Hc2, which can reach tens of tesla. Nb3Sn, NbTi and cuprates are type II and are exactly what superconducting magnets use. (Nb and V are type II among the elements.)
  5. MCQWarm-up

    For many conventional superconductors Tc∝M−1/2, where M is the isotopic mass. This isotope effect shows that
    1. lattice vibrations (phonons) take part in forming the superconducting state
    2. the nuclei carry the supercurrent
    3. superconductivity is a magnetic effect
    4. heavier atoms always make better superconductors
    Answer and solution

    Answer: A

    Phonon frequencies scale as M−1/2; BCS gives kBTc≈1.13ℏωDe−1/N(0)V, so Tc∝ωD∝M−1/2. The electron-phonon interaction provides the attraction that binds Cooper pairs. Heavier isotopes lower Tc.
  6. MCQWarm-up

    Which of these elements does NOT become superconducting at ordinary pressure, however far it is cooled?
    1. Aluminium
    2. Lead
    3. Niobium
    4. Copper
    Answer and solution

    Answer: D

    Aluminium (1.2 K), lead (7.2 K) and niobium (9.2 K) are all superconductors. The best ordinary conductors, copper, silver and gold, have never been seen to superconduct: their electrons couple only weakly to the lattice vibrations, the same weak scattering that makes them good normal conductors.

    Why people get this wrong: Good normal conductivity does not mean a tendency to superconduct; often it is the opposite.

  7. NATStandard

    Lead has Tc=7.2 K and a critical field following Bc(T)=Bc(0)[1−(T/Tc)2]. The temperature at which its critical field is half its value at absolute zero is ______ K (to two decimal places).
    Answer and solution

    Answer: 5.09 K (±0.02)

    1−(T/Tc)2=12 gives (T/Tc)2=12, so T=Tc/2=7.2/1.414=5.09 K. The critical field falls slowly at first and fastest near Tc.

    Why people get this wrong: Tc/2=3.6 K would leave Bc=34Bc(0): the curve is a parabola, not a straight line.

  8. MSQStandard

    MRI and particle-accelerator magnets are wound from type-II superconductors such as NbTi. Which statements give correct reasons?
    1. Type-II materials stay superconducting up to an upper critical field Bc2 that can exceed 10 T.
    2. Pinning of vortices on defects lets the wire carry large currents in high fields without dissipation.
    3. The critical fields of type-I elements are typically below 0.2 T, too low for strong magnets.
    4. Type-II magnets need no cooling once they are energised.
    Answer and solution

    Answer: A, B, C

    In type II the field enters as vortices from Bc1 up to Bc2, which is about 10-15 T for NbTi and 25-30 T for Nb3Sn. Moving vortices would dissipate energy, so the wire is made with defects that pin them. Type-I elements lose superconductivity at their thermodynamic Bc (lead about 0.08 T). All these magnets must be kept below Tc, usually in liquid helium near 4 K.

    Why people get this wrong: Persistent current needs no power supply, but the coil still has to be kept cold.

← All topics · Timed mock test →