Home / Courses / IIT JAM Physics / Practice / Phase transitions and critical phenomena

Phase transitions and critical phenomena

Statistical physics · 8 questions and templates for IIT JAM Physics, in order from warm-up to top rank. Check each answer, then read the full solution.

Loading questions… (they need JavaScript; nothing you type is sent anywhere)

Written questions with solutions

The same questions as a list, so you can print them or read without the practice box. Templates (fresh numbers) appear only in the practice box above.

  1. MCQWarm-up

    Water and steam coexist at 100∘C and 1 atm. Which molar quantity has the same value in both phases?
    1. The molar Gibbs energy
    2. The molar entropy
    3. The molar volume
    4. The molar enthalpy
    Answer and solution

    Answer: A

    Two phases coexist in equilibrium only if moving a molecule from one to the other does not change G: their chemical potentials (molar Gibbs energies) are equal. Entropy, volume and enthalpy all jump; the jumps in S and H give the latent heat L=TΔS=ΔH, and the jump in V appears in the Clausius-Clapeyron equation.

    Why people get this wrong: At a first-order transition the first derivatives of G jump while G itself is continuous.

  2. NATStandard

    1.0 kg of water is held in a rigid 0.50 m3 vessel at 100∘C, where liquid and vapour coexist (specific volumes 0.001043 and 1.672 m3/kg). The fraction of the mass that is vapour is ______ (three decimal places).
    Answer and solution

    Answer: 0.299 (±0.002)

    With vapour fraction x, the specific volume is v=(1−x)vl+xvg, so x=v−vlvg−vl=0.5−0.0010431.672−0.001043=0.299 (the lever rule). Although only 30% of the mass is vapour, it fills almost all of the volume.

    Why people get this wrong: The vapour fills over 99.9% of the volume; the question asks for its share of the mass.

  3. MCQStandard

    Pure water can be cooled several degrees below 0∘C without freezing, but a ferromagnet cooled through its Curie point in zero field cannot stay non-magnetic. The reason is that
    1. water has a much larger heat capacity than iron
    2. the Curie point depends on pressure, the freezing point does not
    3. magnetic forces act faster than the forces between water molecules
    4. a first-order transition has a free-energy barrier (a new phase must nucleate), while at a continuous transition the old state becomes unstable at once
    Answer and solution

    Answer: D

    At a first-order transition the two phases are separate minima of the free energy; below the melting point the liquid is still a local minimum, and forming ice requires a nucleus whose surface energy creates a barrier. So the liquid can persist (supercooling). At a continuous transition the single minimum at m=0 splits: below Tc the old state is a maximum, so fluctuations destroy it immediately. Hysteresis and metastability are marks of first-order transitions.

    Why people get this wrong: Supercooling is not about how fast heat is removed; it needs a barrier, which only first-order transitions have.

  4. NATExam level

    The vapour pressure of ice is 611 Pa at 273.16 K, and its molar latent heat of sublimation is 51.0 kJ/mol. Treating the vapour as ideal and L as constant, the vapour pressure of ice at 263.15 K is ______ Pa (R=8.314 J mol−1 K−1).
    Answer and solution

    Answer: 260 (±3)

    Integrating dln⁡P/dT=L/RT2: ln⁡P2P1=−LR(1T2−1T1)=−6134×(3.8001−3.6608)×10−3=−0.854. So P2=611×e−0.854=611×0.426=260 Pa. Sublimation, not evaporation, sets the humidity over snow; its latent heat is the sum of the heats of melting and of evaporation.

    Why people get this wrong: Using the latent heat of evaporation (45 kJ/mol near 0∘C) gives about 287 Pa, the vapour pressure over supercooled water, not over ice.

← All topics · Timed mock test →