Op-amp circuits
Electronics · 14 questions and templates for IIT JAM Physics, in order from warm-up to top rank. Check each answer, then read the full solution.
Loading questions… (they need JavaScript; nothing you type is sent anywhere)
Written questions with solutions
The same questions as a list, so you can print them or read without the practice box. Templates (fresh numbers) appear only in the practice box above.
-
MCQWarm-up
For an ideal op-amp working with negative feedback (output not saturated), the two rules used to analyse the circuit are- the output current is zero and the output voltage is zero
- the inputs draw no current and the output resistance is infinite
- the inputs draw no current and the two input voltages are equal
- the input voltages differ by the supply voltage
Answer and solution
Answer: C
Infinite input resistance means no current into either input. Infinite open-loop gain with a finite output means : the feedback forces the inputs to the same voltage (a virtual short). The second rule fails if there is no negative feedback or if the output saturates.Why people get this wrong: The virtual short is a result of negative feedback, not a property of the chip; a comparator has none.
-
MCQWarm-up
An op-amp is used open loop as a comparator. With V and V, the output is- at the negative saturation level
- at the positive saturation level
- about V
- zero, because the inputs are nearly equal
Answer and solution
Answer: A
Open loop, V. With that is far beyond the rails, so the output sits at . There is no feedback to make the inputs equal.Why people get this wrong: Applying the virtual-short rule to a circuit with no negative feedback.
-
MSQWarm-up
Which statements about an op-amp Schmitt trigger are correct?- Its switching thresholds for rising and falling inputs differ (hysteresis)
- It uses positive feedback
- It gives a clean single transition for a slow, noisy input if the noise is smaller than the hysteresis
- Its two inputs stay at equal voltages at all times
Answer and solution
Answer: A, B, C
Feedback to the non-inverting input makes the threshold depend on the output state, so once it has switched the input must move back past the other threshold. Noise smaller than the gap cannot cause chatter. With positive feedback the output sits at a rail and the inputs are generally not equal.Why people get this wrong: The virtual short belongs to negative feedback only.
-
MCQWarm-up
An ideal inverting summing amplifier has feedback resistor k. Input V enters through k and input V through k. The output is- V
- V
- V
- V
Answer and solution
Answer: B
The inverting input is a virtual ground, so each input sends into the summing node: mA. All of it flows through : V.Why people get this wrong: Adding the input voltages directly ( V) ignores that the k input is weighted twice as strongly.
-
MCQStandard
A 555 timer in astable mode has k, k and F. Its frequency is about- 1.37 kHz
- 686 Hz
- 343 Hz
- 6.9 kHz
Answer and solution
Answer: B
The capacitor charges through and discharges through , between and ; each takes time constants. ms, so Hz. Duty cycle .Why people get this wrong: Using in both halves gives 1.31 kHz-type answers.
-
MCQStandard
An inverting first-order low-pass filter has input resistor k, and k in parallel with nF in the feedback path. Its DC gain and cut-off frequency are- and about 1 kHz
- and about 10 kHz
- and about 1 kHz
- and about 6.3 kHz
Answer and solution
Answer: A
DC gain . The pole is set by the feedback pair: kHz. The input resistor does not enter the cut-off.Why people get this wrong: Using the input resistor with gives 10 kHz.
-
MCQStandard
An inverting amplifier with an ideal op-amp has k and k. It is driven by a signal source whose internal resistance is k. The gain from the source's open-circuit voltage to the output isAnswer and solution
Answer: C
The input resistance of an inverting amplifier is only , because the inverting input is a virtual ground. The source resistance adds in series: the current is , so . A non-inverting stage or a buffer in front would avoid this loss.Why people get this wrong: Treating the amplifier's input resistance as infinite, as for a non-inverting amplifier.
-
NATStandard
Two voltages, V and V, are each connected through a k resistor to the non-inverting input of an ideal op-amp (nothing else is connected to that input). The op-amp has k from its inverting input to ground and k from the output to its inverting input. The output is ______ V.Answer and solution
Answer: 6 (±0.01)
No current enters the non-inverting input, so the two equal resistors average the inputs: V (superposition, or Millman's theorem). The stage has gain , so V.Why people get this wrong: Applying the gain to the sum V, as if it were an inverting summer, gives V.
-
MCQStandard
In a series voltage regulator an op-amp drives a pass transistor so that a fraction of the output, taken from a divider with k (output to feedback node) and k (feedback node to ground), equals a V reference at the other op-amp input. The regulated output is- V
- V
- V
- V
Answer and solution
Answer: D
The loop forces the divided output to equal the reference: V, so V. The circuit is a non-inverting amplifier of the reference, with the transistor supplying the load current.Why people get this wrong: V uses instead of .
-
MCQStandard
Two log amplifiers produce outputs proportional to and (with ). Their outputs are added by a summing amplifier, and the sum drives an antilog (exponential) amplifier. Apart from a constant scale factor, the final output is proportional toAnswer and solution
Answer: A
, and the antilog stage undoes the logarithm, giving an output . This is an analogue multiplier; replacing the adder by a difference amplifier would divide instead. The inputs must stay positive, since a log amplifier only works in one quadrant.Why people get this wrong: would need a subtractor, not an adder, before the antilog stage.
-
MCQExam level
A 555 timer in monostable mode has k and F. The output pulse lasts about- 0.69 s
- 2.2 s
- 11 s
- 1.1 s
Answer and solution
Answer: D
The capacitor charges from 0 towards and the pulse ends at : s.Why people get this wrong: 0.69RC belongs to the astable half periods (charging from 1/3 to 2/3).