Elasticity: stress, strain and the elastic constants
Mechanics and properties of matter · 8 questions and templates for GATE Physics, in order from warm-up to top rank. Check each answer, then read the full solution.
Loading questions… (they need JavaScript; nothing you type is sent anywhere)
Written questions with solutions
The same questions as a list, so you can print them or read without the practice box. Templates (fresh numbers) appear only in the practice box above.
-
MCQStandard
For an isotropic elastic material, the theoretical range of Poisson's ratio allowed by the requirement that and be positive is- 0 to 1
- −1 to 1/2
- 1/2 to 1
- −1/2 to 1/2
Answer and solution
Answer: B
From with : . From with : . Most real materials lie between 0.2 and 0.5; some engineered foams have negative values. -
MSQExam level
For an isotropic solid with moduli , , and Poisson's ratio , which relations are correct?- If , the bulk modulus is zero.
Answer and solution
Answer: A, B, C
The first two are the standard results. Eliminating between them: and , so , i.e. (true). For , so is infinite: the material is incompressible (fourth false). -
MSQHard
A wire of an isotropic material is stretched slightly. With its Poisson's ratio, which statements are true?- If its volume does not change
- can never be negative
- If its volume increases
- As the bulk modulus becomes very large compared with
Answer and solution
Answer: A, C, D
With longitudinal strain , each transverse strain is , so : zero at , positive for . as (nearly incompressible, like rubber). Theory allows , and auxetic foams really do have negative .Why people get this wrong: "Stretching always thins the wire so much that the volume falls": only if , which is impossible.
-
MCQTop rank
A uniform rod (density , Young's modulus , length ) spins at angular speed about a perpendicular axis through one end. Its total elongation isAnswer and solution
Answer: B
Strain at : . Integrate: . -
NATTop rank
A steel rod and an aluminium rod, each 0.5 m long with the same cross-section, are joined end to end and fitted without stress between two rigid walls. The pair is warmed by 40 K. With steel Pa, K⁻¹ and aluminium Pa, K⁻¹, the compressive stress is ______ MPa (one decimal place).Answer and solution
Answer: 72.6 MPa (±0.5)
Same force and same area, so the same stress in both. The total length cannot change: free expansion must equal elastic shortening . So Pa.Why people get this wrong: Working out each rod's own clamped stress () gives 96 and 64 MPa; the rods share one stress because they push on each other.
-
MCQTop rank
A square face of a block is sheared through a small angle (pure shear of the top relative to the bottom). The fractional change in length of one of the face diagonals isAnswer and solution
Answer: B
Side ; the top moves sideways by . The diagonal from to becomes , of length . So one diagonal stretches by and the other shrinks by . This is why shear equals a stretch plus a squeeze at , and leads to .Why people get this wrong: Taking the diagonal strain equal to the shear angle.
-
NATTop rank
A steel cable 200 m long with cross-section 1.0 cm² hangs from its top end carrying nothing ( kg/m³, Pa, m/s²). The elastic energy stored in it by its own weight is ______ J (two decimal places).Answer and solution
Answer: 3.9 J (±0.04)
At distance above the bottom, the stress is . Energy per volume , so J. Check: the weight N and the stretch mm give .Why people get this wrong: J assumes the whole weight acts at the bottom; the stress here grows from zero, which gives .