X-ray diffraction and Bragg's law
Solid state physics and devices · 8 questions and templates for CSIR NET Physics, in order from warm-up to top rank. Check each answer, then read the full solution.
Loading questions… (they need JavaScript; nothing you type is sent anywhere)
Written questions with solutions
The same questions as a list, so you can print them or read without the practice box. Templates (fresh numbers) appear only in the practice box above.
-
MCQExam level
In the Ewald construction (wave vector of length ending at the reciprocal-lattice origin), a diffracted beam appears when- a reciprocal-lattice point lies on the sphere of radius centred at the start of
- the sphere encloses the reciprocal-lattice origin
- a direct-lattice point lies on the sphere
- the sphere has radius equal to the lattice constant
Answer and solution
Answer: A
Elastic scattering keeps , so the scattered wave vector ends on the sphere. The Laue condition requires . Both hold when a reciprocal-lattice point (other than the origin) lies on the sphere; the diffracted beam then points from the sphere's centre to that point.Why people get this wrong: Using the direct lattice: the construction lives in reciprocal space.
-
MSQHard
Which statements are correct?- In Bragg diffraction the X-ray photon gives part of its energy to the lattice.
- The Laue condition is equivalent to Bragg's law.
- A monochromatic beam on a fixed single crystal in a general orientation always gives several diffracted beams.
- The shortest reciprocal-lattice vector perpendicular to the planes has length .
Answer and solution
Answer: B, D
Energy loss: false: Bragg peaks are elastic (); inelastic scattering by phonons gives the weak diffuse background. Laue = Bragg: true: with gives . Always several beams: false: in general no reciprocal-lattice point lies exactly on the Ewald sphere, which is why one rotates the crystal, uses a powder, or uses white radiation. : true.Why people get this wrong: Expecting diffraction from any crystal in any orientation: a monochromatic beam needs the right angle.
-
NATTop rank
A zinc-blende crystal has atom A at the fcc sites and atom B displaced by from each. Take and for both reflections. The ratio is ______ (to two decimal places).Answer and solution
Answer: 5.9 (±0.05)
with factor 4. : , so and . : , , . Ratio . Unlike diamond, survives because A and B differ.Why people get this wrong: Adding the B wave in phase for () instead of a quarter cycle out of phase.
-
MSQTop rank
An alloy AB has a bcc arrangement of sites. Above a critical temperature A and B occupy the sites at random; below it, A takes the corners and B the body centres. Which statements are correct?- In the random phase, reflections with odd are absent.
- In the ordered phase, extra (superlattice) reflections with odd appear.
- The superlattice reflections have intensity proportional to .
- The ordered phase still has a bcc Bravais lattice.
Answer and solution
Answer: A, B, C
Random: every site holds an average atom , which is bcc, so odd cancel (true). Ordered: , so odd lines appear with (true), and their intensity goes as (true). Bravais lattice: false: when the corner and centre differ, the lattice is simple cubic with a two-atom basis (the CsCl type). The growth of superlattice lines below the critical temperature measures the degree of order.Why people get this wrong: If A and B have nearly equal form factors (neighbours in the periodic table), the superlattice lines are too weak for X-rays; neutrons are then used.
-
NATTop rank
An X-ray tube run at kV gives a continuous spectrum from its short-wavelength limit upward. A fixed crystal presents planes with Å at a glancing angle of . Assuming every wavelength above the limit is present, how many orders are reflected by these planes at the same time?Answer and solution
Answer: 3
Short-wavelength (Duane-Hunt) limit: nm Å. The planes reflect Å. These must be at least Å: . So orders (, , Å) all appear in the same spot.Why people get this wrong: Thinking a Laue spot has one wavelength: harmonics , land in the same direction.
-
MCQTop rank
Peak widths (in radians, instrument width removed) of a powder are analysed with (Williamson-Hall), where is the crystallite size and the microstrain. Plotting against for many peaks,- the slope gives the size and the intercept gives the strain
- the intercept gives the size and the slope gives the strain
- both the size and the strain come from the slope
- a horizontal line means the sample is strained and has very large grains
Answer and solution
Answer: B
The equation is a straight line with and . Intercept , so . Slope . A horizontal line () means no strain: the broadening is all from small crystallites, as Scherrer assumes.Why people get this wrong: Size broadening goes as and strain broadening as ; the plot separates them because only strain depends on after multiplying by .
-
MCQTop rank
A silicon (diamond structure) crystal set to reflect from its planes is used as a monochromator for a white X-ray beam. Which shorter wavelength also leaves in the same direction with appreciable intensity?- , reflected by
- only, since is forbidden
- None: a crystal reflects only one wavelength at a given angle
- , reflected by
Answer and solution
Answer: D
At the same angle, planes reflect . For the diamond structure the structure factor of an all-even vanishes when : has sum and is (nearly) forbidden, so is suppressed. (all odd) is allowed, so passes. (Further on, , with sum , is allowed too, so also passes, more weakly.) This is why Si(111) monochromators are prized: the second harmonic is missing.Why people get this wrong: Assuming every higher order is present ignores the diamond-structure absences.