Electromagnetic waves in matter, conductors and plasmas
Electricity and magnetism · 84 questions and templates for CSIR NET Physics, in order from warm-up to top rank. Check each answer, then read the full solution.
Loading questions… (they need JavaScript; nothing you type is sent anywhere)
Written questions with solutions
The same questions as a list, so you can print them or read without the practice box. Templates (fresh numbers) appear only in the practice box above.
-
MCQWarm-up
The intrinsic impedance of a lossless non-magnetic medium with is closest toAnswer and solution
Answer: C
.Why people get this wrong: Dividing by instead of gives ; multiplying gives .
-
MCQWarm-up
In a good conductor, the skin depth depends on the frequency as- it does not depend on
Answer and solution
Answer: B
, so : four times the frequency halves the skin depth.Why people get this wrong: For a poor conductor the attenuation length is nearly independent of ; do not mix the two limits.
-
MCQWarm-up
The plasma frequency of a free-electron gas of number density is proportional toAnswer and solution
Answer: D
. Numerically Hz with in m.Why people get this wrong: Denser plasma has a higher cutoff, but only as the square root.
-
NATWarm-up
A medium has and conductivity S/m. A free charge placed inside decays with time constant . Find in ns (to one decimal place).Answer and solution
Answer: 22.1 ns (±0.2)
Continuity plus Gauss plus Ohm give , so with s ns.Why people get this wrong: Forgetting and using alone gives a value five times too small.
-
MCQWarm-up
For a plane wave inside a good conductor, the magnetic field relative to the electric field- is in phase with it
- lags it by
- leads it by
- lags it by
Answer and solution
Answer: B
With and , carries an extra phase in . At a fixed point that peak arrives later in time, so lags by .Why people get this wrong: In a perfect dielectric the two are in phase; the comes from .
-
MCQWarm-up
A material counts as a good conductor at angular frequency whenAnswer and solution
Answer: A
Ampère-Maxwell has : conduction current against displacement current. Good conductor: the conduction current dominates, . The same material can be a good conductor at low frequency and a dielectric at high frequency.Why people get this wrong: and have different units, so they cannot be compared.
-
MCQWarm-up
A light wave travels through a non-magnetic, lossless medium with relative permittivity . Its speed isAnswer and solution
Answer: B
. The refractive index is .Why people get this wrong: Dividing by instead of gives .
-
NATStandard
Aluminium has S/m and . Its skin depth at the mains frequency of 50 Hz is ______ mm (to one decimal place).Answer and solution
Answer: 12 mm (±0.15)
m mm. This is why thick power-line conductors use a steel core: the outer centimetre carries the current.Why people get this wrong: Using instead of gives a value too large.
-
NATStandard
A laboratory plasma has electron density m. Its plasma frequency is ______ GHz (to two decimal places).Answer and solution
Answer: 1.8 GHz (±0.02)
, so Hz Hz. Microwaves below 1.8 GHz are reflected by this plasma.Why people get this wrong: Quoting ( rad/s) when is asked.
-
MCQStandard
The dispersion relation for transverse electromagnetic waves in a cold, collisionless electron plasma isAnswer and solution
Answer: D
Each electron obeys , so and . Then , i.e. . Real needs .Why people get this wrong: The relation has the same form as : the plasma gives the photon an effective mass.
-
MCQStandard
For waves in a cold plasma above the plasma frequency, the product of phase velocity and group velocity isAnswer and solution
Answer: C
From : and , so . With , the group velocity is below .Why people get this wrong: is , not .
-
MSQStandard
For a plane wave of angular frequency in a good conductor with skin depth , which statements are true?- The wavelength inside is
- The phase velocity is
- The ratio is much larger than
- The field amplitude falls by a factor in one skin depth
Answer and solution
Answer: A, B, D
In a good conductor : the real part gives and ; the imaginary part gives decay . And , which is much less than : the field is mostly magnetic.Why people get this wrong: In a conductor the wave is nearly all magnetic, the opposite of a large .
-
NATStandard
Moist soil has S/m and . Its loss tangent at 10 MHz is ______ (to two decimal places).Answer and solution
Answer: 1.8 (±0.02)
S/m, so . Neither limit applies: conduction and displacement currents are comparable, so the full complex must be used.Why people get this wrong: Forgetting makes the soil look like a good conductor (ratio 18).
-
MCQStandard
The surface resistance of a good conductor (the real part of its surface impedance) isAnswer and solution
Answer: A
The current flows effectively in a layer of thickness , so a square of surface has resistance . The power absorbed per unit area is .Why people get this wrong: Check units: is in ohms; is not.
-
MCQStandard
A wave of angular frequency falls on a cold, collisionless plasma. Inside the plasma the wave- propagates with phase velocity less than
- is evanescent: its amplitude decays and the energy is reflected
- is absorbed by collisions and turned into heat
- travels at exactly
Answer and solution
Answer: B
For , , so and the field falls as . The average Poynting vector inside is zero (E and B are out of phase), so with no collisions nothing is absorbed: the wave is totally reflected.Why people get this wrong: Decay does not mean absorption: an evanescent field stores energy but carries none on average.
-
NATStandard
A wave travels three skin depths into a conductor. By how many decibels has its power fallen? (to one decimal place)Answer and solution
Answer: 26.1 dB (±0.1)
The field falls as , the power as . At the power ratio is , i.e. dB (8.686 dB per neper of field attenuation).Why people get this wrong: Using the field decay in gives 13.0 dB, half the answer.
-
MCQStandard
In a region of normal dispersion (, ), the group velocity and phase velocity satisfy- always
Answer and solution
Answer: D
with gives . With the denominator exceeds , so .Why people get this wrong: The group index is , not (the minus sign belongs to the form with ).
-
MSQStandard
For a transverse wave with in a cold electron plasma, which statements are true?- The phase velocity is greater than
- The group velocity is less than
- The refractive index is less than 1
- Waves of every frequency can travel through it
Answer and solution
Answer: A, B, C
, so , and . Below , is imaginary and the wave cannot travel, so the last statement is false.Why people get this wrong: A phase velocity above carries no information and breaks no rule.
-
MCQStandard
Inside a good conductor (conductivity , permeability ), the amplitude ratio of a plane wave of angular frequency isAnswer and solution
Answer: B
and . So , far larger than .Why people get this wrong: is times too big: it uses only the real part of twice.
-
NATStandard
A MHz radio wave travels through a large block of lossless, non-magnetic plastic with . Its wavelength inside the plastic is ______ cm (to one decimal place).Answer and solution
Answer: 33.3 cm (±0.2)
The frequency stays MHz; the speed drops to with . m cm, against cm in air.Why people get this wrong: Changing the frequency instead of the wavelength: frequency is fixed by the source.
-
MCQStandard
For a plane wave in a lossless, linear, non-magnetic dielectric of refractive index , the ratio of the electric to the magnetic energy density, , isAnswer and solution
Answer: D
and . In the wave with , so . The energy is shared equally, as in vacuum; the medium changes to in exactly the way needed.Why people get this wrong: Noticing that raises , but forgetting that raises by the same factor.
-
NATExam level
A non-magnetic medium has and S/m. At 100 MHz it is a low-loss medium. After what distance does the field amplitude fall to ? (in m, to one decimal place)Answer and solution
Answer: 10.6 m (±0.1)
Check: S/m , so low-loss. Then with : Np/m and m.Why people get this wrong: The good-conductor formula gives 1.6 m, wrong here because .
-
NATExam level
For a plane wave in copper ( S/m, ) at 1.0 GHz, the ratio of time-averaged magnetic to electric energy density is . Find (to two decimal places).Answer and solution
Answer: 1.04 (±0.01)
.Why people get this wrong: In vacuum the two energies are equal; in a conductor the magnetic part wins by the loss tangent.
-
MSQExam level
Treat the conduction electrons of an alkali metal as a free-electron plasma with plasma frequency (collisions neglected). Which statements are true?- The metal is transparent for
- It reflects totally for
- For typical metals lies in the ultraviolet
- is positive for
Answer and solution
Answer: A, B, C
is negative below (so is imaginary and ) and positive above (the metal transmits). With m, rad/s: ultraviolet. This is the ultraviolet transparency of the alkali metals.Why people get this wrong: The sign of below is what makes metals shiny.
-
MCQExam level
A wave of angular frequency meets a cold plasma. The distance over which the field amplitude falls by inside is- for every
Answer and solution
Answer: C
gives , so the length is . It tends to for and grows without bound as .Why people get this wrong: is only the low-frequency limit.
-
NATExam level
Radio pulses from a pulsar cross interstellar plasma with electron column density pc cm ( pc m). For the extra group delay is . By how many milliseconds does the 400 MHz pulse arrive after the 800 MHz pulse? (nearest ms)Answer and solution
Answer: 583 ms (±3)
Convert: pc cm m. The constant SI. So s.Why people get this wrong: Forgetting the cm to m factor of .
-
MCQExam level
In the Lorentz (bound-electron) model of a dielectric, close to a resonance with small damping, which description is correct?- rises with and absorption is smallest at
- exactly and there is no absorption
- is constant and absorption grows as
- absorption peaks and falls with (anomalous dispersion)
Answer and solution
Answer: D
. The imaginary part (absorption) peaks at with width . The real part rises below the line, then falls through the line (: anomalous dispersion), then rises again above it.Why people get this wrong: Normal dispersion holds away from resonances; anomalous dispersion is confined to the absorption band.
-
NATExam level
The surface resistance of copper ( S/m) at 10 GHz is ______ m (to one decimal place).Answer and solution
Answer: 26.1 mΩ (±0.3)
. Equivalently with m.Why people get this wrong: is the same as ; do not use in the first form.
-
MCQExam level
The magnitude of the intrinsic impedance of a good conductor, compared with , is- about equal to
- much larger than
- smaller by the factor
- exactly zero
Answer and solution
Answer: C
with , so . For copper at 1 GHz that is about 12 m. The tiny impedance is why a metal reflects almost everything: .Why people get this wrong: Only a perfect conductor has exactly zero impedance.
-
NATExam level
A 3.0 GHz signal travels through a plasma whose plasma frequency is 1.8 GHz. Its group velocity is ______ (to two decimal places).Answer and solution
Answer: 0.8 (±0.005)
. The phase velocity is ; their product is .Why people get this wrong: Using without squaring.